Electrolux EHF6241FMK Benutzerinformation Seite 13

Problem
and a number come on. There is an error in the
You can hear a constant
beep noise.
comes on.
8.2 If you cannot find a
solution...
If you cannot find a solution to the
problem yourself, contact your dealer or
an Authorised Service Centre. Give the
data from the rating plate. Give also
three digit letter code for the glass
ceramic (it is in the corner of the glass
9. TECHNICAL DATA
9.1 Rating plate
Model EHF6241FMK
Typ 60 HAD 03 AO
Ser.Nr. .................
ELECTROLUX
9.2 Cooking zones specification
Cooking zone
Left front
Left rear
Possible cause
hob.
The electrical connection is
incorrect.
The second phase of the
power supply is missing.
Nominal Power (Max heat set‐
ting) [W]
750 / 2200
1200
Remedy
Deactivate the hob and ac‐
tivate it again after 30 sec‐
onds. If
again, disconnect the hob
from the electrical supply.
After 30 seconds, connect
the hob again. If the prob‐
lem continues, speak to an
Authorised Service Centre.
Disconnect the hob from
the electrical supply. Ask a
qualified electrician to
check the installation.
Check if the hob is correct‐
ly connected to the electri‐
cal supply. Remove the
fuse, wait one minute, and
insert the fuse again.
surface) and an error message that
comes on. Make sure, you operated the
hob correctly. If not the servicing by a
service technician or dealer will not be
free of charge, also during the warranty
period. The instructions about the
Service Centre and conditions of
guarantee are in the guarantee booklet.
PNC 949 492 284 01
220 - 240 V 50 - 60 Hz
Made in Romania
6.4 kW
Cooking zone diameter [mm]
120 / 210
145
ENGLISH 13
comes on