GreenWorks G40LTK2 Bedienungshandbuch Seite 9

1. Remove the screws from the trimmer head with a
Phillips head screwdriver (not included).
2. Put the guard onto the trimmer head.
3. Align the screw holes on the guard with the screw
holes on the trimmer head.
4. Tighten the screws.
3.4 ASSEMBLE THE SHAFT
Figure 6.
1. Loosen the screw on the coupler.
2. Push in the release button on the lower shaft.
3. Align the release button with the positioning hole
and slide the two shafts.
4. Turn the lower shaft until the button locks into the
positioning hole.
NOTE
The release button must be fixed in the positioning
hole. Using the wrong hole could lead to personal
injury, or damage to the unit.
5. Tighten the screw with the hex wrench.
3.5 ATTACH THE AUXILIARY HANDLE
Figure 7 - 8.
1. Remove the knob from the handle.
2. Attach the auxiliary handle on the shaft.
3. Set the auxiliary handle in the comfortable position.
4. Tighten the auxiliary handle with the knob.
3.6 INSTALL THE BATTERY PACK
Figure 9.
WARNING
• If the battery pack or charger is damaged, replace
the battery pack or the charger.
• Stop the machine and wait until the motor stops
before you install or remove the battery pack.
• Read, understand, and follow the instructions in
the battery and charger manual.
1. Align the lift ribs on the battery pack with the
grooves in the battery compartment.
2. Push the battery pack into the battery compartment
until the battery pack locks into place.
3. When you hear a click, the battery pack is installed.
3.7 REMOVE THE BATTERY PACK
Figure 10.
1. Push and hold the battery release button.
2. Remove the battery pack from the machine.
English
4 OPERATION
Before you operate the machine, read and understand
the safety regulations and the operation instructions.
Be careful when you operate the machine.
4.1 START THE MACHINE
Figure 11.
1. Push the lock-out button and pull the trigger.
4.2 STOP THE MACHINE
Figure 11.
1. Release the trigger to stop the machine.
4.3 OPERATION TIPS
Figure 12.
Keep clearance between the body and the machine.
Do not operate the machine without guard in place.
Follow these tips when you use the machine:
• Keep the machine connected to the correctly worn
harness.
• Keep a firm hold with two hands on the machine
while you operate the machine.
• Cut tall grass from the top down.
If grass winds around the trimmer head:
• Remove the battery pack.
• Remove the grass.
4.4 CUTTING TIPS
Figure 13.
• Tilt the machine towards the area to be cut. Use the
tip of the cutting line to cut grass.
• Move the machine from right to left to prevent
thrown debris toward the operator.
• Do not cut in dangerous areas.
• Do not force the trimmer head into uncut grass.
• Wire and picket fences cause cutting line wear and
breakage. Stone and brick walls, curbs, and wood
can wear the cutting line quickly.
5
IMPORTANT
WARNING
WARNING
WARNING
EN