Product Description; Prior To First Use; Boiling Water - Inventum HW917B Gebrauchsanleitung

2

product description

1. Spout
2. Anti-scale filter
3. Lid
4. Lid opening knob
5. Handle
6. Water level indicator
7. Temperature gauge
8. On / off switch with indicator led
9. Power base
3

prior to first use

Follow these instructions when using the kettle for the first time:
Carefully remove the kettle from the packaging and remove
all packaging material. Keep the packaging (plastic bags and
cardboard) out of the reach of children. After unpacking the
appliance, check it for external damage that may have occurred
during transport. Place the kettle on a heat-resistant flat
surface.
The minimum water filling volume is 0.7 litres. The maximum
filling volume is 1.7 litres.
Prior to use, the appliance must be filled to the maximum twice
and the water must be brought to the boil twice. Throw away
the boiled water and rinse the appliance with cold water. The
appliance is now ready for use.
The kettle is only suitable for boiling water. Never fill the kettle
with milk, tea, coffee or other instant drinks.
1
2 6
4

boiling water

Check that the voltage stated on the information plate
matches the voltage used in your region.
Place the connection base on a flat, stable surface. Insert the
plug in an earthed wall socket. Place the kettle on the base.
If necessary, excess cord can be stored in the bottom of the
connection base by rolling up the cord.
1. Open the lid by pressing the button.
2. Fill the kettle with the required volume of water and close
the lid by pressing it close.
3. Place the kettle on the connection base and make sure
the plug is in the socket.
4. Switch on the kettle by pressing down the on/off switch at
position 1. The indicator led lights up. The kettle starts to
boil the water.
5. The kettle switches off automatically when the water boils.
The indicator led switches off.
Caution: never switch on the kettle when it contains no
water. If, by accident, the kettle is switched on without
water in it, the boil dry safeguard switches off the kettle
automatically. In this case, remove the kettle from the
connection base and allow it to cool down for a few minutes.
Then you can fill the kettle with water and switch it on again.
Check that the lid of the kettle is properly closed. If not, the
kettle does not switch off automatically when the water boils
and continues to boil.
9
English •
3
4
5
7
8
11