Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Remove programming
Use this function only if you wish to remove the programming completely from the controller (e.g. for training purposes or
to debug a defective controller). After deletion, the controller can be manually programmed again.
To remove the saved programming:
1 Press the PROG button for 4 seconds.
While holding down, the PROGRAM LED will remain off for the first 2 seconds, then flash 2 seconds and then switch
off again once the deletion has completed.
2 Release the PROG button.
Internet connection specifications
The connected controller is connected to the resident's home network via the WAN gateway. An IP address will be assigned
to the connected controller by the network router. Via this connection, the controller communicates with Niko Home Control
software, such as the user setting software or the energy software (to consult consumption or production data).
This gate is a DHCP client and will therefore not assign IP addresses to other IP devices.
The router settings needed to establish this connection, correspond with the standard settings of new WiFi router:
• for DNS access outgoing port 53 must be opened
• for data traffic outgoing ports 80, 443 and 22 must be opened
• for (S)NTP outgoing port 123 must be opened.
Register the installation
Have the MAC address and serial number (SN) of the connected controller light ready (this data is printed on the controller
and can also be found on the included label). Surf to
this MAC address and serial number. Enter the data of the customer or ask him to fill it out.
The installation is now accessible for upgrades and any possible interventions by Niko customer service.
https://mynikohomecontrol.niko.eu
and register your installation using
Connected controller light
31
Werbung
