Niko 550-00002 Bedienungsanleitung Seite 30

6 Press the PROG button briefly.
The PROG LED is no longer lit and the controller exits the manual PROGRAM mode.
7 Repeat steps 3 to 6 for each function you wish to program.
• The manually programmed outputs will be overwritten once you start programming the installation via
computer.
• As soon as the installation has been programmed via computer, you can no longer program the
installation manually.
• If you manually operate outputs via the buttons on the modules, the controller may modify your input at
any time.
Programming the installation
Program the installation with the most recent version of the programming software (available on www.niko.eu). Only once
the programming has been completed, it can be loaded to the connected controller. If the installation is expanded and
additional modules are added, you will need to reprogram the installation. The programming may not contain any elements
which is not supported by this version of the connected controller such as a smartphone, touchscreen or access control.
Such programming will not be able to be saved. If these functions are desired, the standard version of the connected
controller must be installed. (See Controller on page 10)
Follow the steps below to program the installation:
1 Connect the installation to the mains power supply.
2 Press the TEST button and verify that the STATUS LED of each module lights up. This way you are ensured that all
sliding controls between the modules were slid closed properly.
3 Connect the computer to the installation:
• If a router is already present for the home network, you can:
- connect the computer with a free port to the router.
- if it is a WiFi router, connect the computer with the installation wirelessly. This gives the advantage that you
can walk around the home during the addressing of the inputs. To upload the programming to the installation,
we recommend using a wired connection with a free port on the router as such a connection is more reliable
than a WiFi connection.
• If a router is not yet present, you can connect your computer directly to the WAN gateway of the connected
controller. As an IP address is assigned automatically with this connection, it can take up to 2 minutes before the
connection with the connected controller is realized.
1 Start up the programming software and open your installation project.
2 Select "Realisation" from the menu bar and follow the on-screen instructions until all the steps of the programming
process are completed.
3 Disconnect the computer from the installation.
All programmed outputs are now stored in the controller. At any time this programming can be read on the controller.
Create a back-up on your computer and provide the resident with a copy.
30
Connected controller light