Niko 550-00002 Bedienungsanleitung Seite 28

Check the status of the installation
Using the indication LEDs on the controller
If the Niko Home Control installation functions normally, only the SERVER LED is illuminated on the connected controller
light.
The remaining LEDs are not lit, to help save energy.
If an error occurs, simply switch the installation to TEST mode to check the status of the modules. First press the TEST
button on the controller to switch the installation to TEST mode. The STATUS LEDS indicate the status of each module and
each output. The TEST mode remains active for two minutes.
LED Status
STATUS LED The green
LED lights up
continuously
The green LED
flashes
The orange
LED lights up
continuously
The red LED
lights up
continuously
The LED is
not on
PROGRAM The green
LED LED lights up
continuously
28
Connected controller light
Information
The installation functions normally.
The installation is initializing or is currently
being updated.
A problem has been detected.
A serious problem has been detected.
The controller does not receive power
supply voltage or is defective.
and the controller is in manual PROGRAM
mode.
Possible causes and actions
/
After approximately one minute, the
status ends automatically. Under no
circumstances should the installation be
switched off.
Consult the diagnostics page in the
programming software for more
information (see Using the diagnostics
page on page 29).
Consult the diagnostics page in the
programming software for more
information (see Aan de hand van de
diagnosepagina on page
Check if the TEST mode is active.
Measure the power supply voltage. If
the problem persists, contact the Niko
customer service.
The PROG button has been pressed to
set the controller in manual programming
mode. Push the PROG button again to
leave this mode.
29).