SELFSAT -H50dCSS Bedienungsanleitung Seite 9

Step 5: SELFSAT-H50dCSS installation and how to use
Since the SELFSAT-H50dCSS antenna provides one dCSS output and two legacy outputs, the user can
select different port upon your STB types (dCSS compatible or traditional).
Make sure that connect traditional STB(s) to legacy output(s) and connect dCSS compatible STB to SCR
/ dCSS output by referring the below image.
Note
SELFSAT-H50dCSS antenna includes protection caps for the outputs. Please put the
protection cap on the outputs when you do not use the ports to prevent water penetra-
tion. Also, when you are using the port, please keep the connector protection cap and do
not lose it for later use.
1) Connect the SELFSAT-H50dCSS antenna to the STB
Once you have installed the antenna in an open space or mounted the way you want it to be, the next step is
to connect them all together.
In order to be able to watch your favorite satellite programs, you need to connect your satellite antenna to a
STB with a cable. The cable between the antenna and the STB should not exceed 30m as it
will decrease the quality of the signal. The use of a long or bad quality cable and/or unisolated jacks can cause
lowering the signal level, it would be preferable to use an RG6 Coaxial cable (HF 17VATC or 19VATC cable), in
order to minimize a signal loss.
Just connect the RF coaxial cable from the SELFSAT-H50dCSS antenna to your STB.
- How to prepare the cable?
8
LEGACY 1
LEGACY 2
SCR / dCSS
CONNECTOR COVER
15mm
8mm
F CONNECTOR
3mm