Kress KG340 Bedienungsanleitung Seite 15

CHANGE THE CUTTING SIZE
J
Beep!
This product could be adjusted to different opening
width.
While product is active, depress the Operator Presence
Switch while simultaneously depressing the ON/OFF
Trigger. 2 seconds later, please release the ON/OFF
Trigger after hearing a beep. Blades will change remove
exchange size between MAX cut opening and small cut
opening in order.
WARNING!: When the product is in the open
position, If you release the Operator Presence
Switch and the On/Off trigger, the product will stay
active for about one minute.
Need to re-run the product-
Within one minute, push the Operator Presence Switch
and later depress the ON/OFF Trigger, then the product
will be re-activated to work. Even if you release the ON/
OFF Trigger while depressing the Operator Presence
Switch, the product will be able to cut if you press the
ON/OFF Trigger within 20 seconds. The LED Light
Indicator will go out and the product will turn off if you
do not press the ON/OFF Trigger within 20 seconds.
The product will be powered down if no action within 1
minute.
STORAGE MODE & SWITCH OFF
K
Beep!
Beep!
While product is active, depress the Operator Presence
Switch while simultaneously depressing the ON/OFF
Trigger. The blades will close and beep once. Continue
to hold until product beeps twice. LED Light Indicator
will turn off, blades will stay closed, and product is now
EN
15