Husqvarna TS 138 Bedienungsanweisung Seite 11

Hood scoop, 1 pcs
Oil drain extension, 1 pcs
Steering wheel, 1 pcs
Center cover for steering wheel, 1 pcs
Steering shaft cover, 1 pcs
Hex bolt for the steering wheel, 1 pcs
Steering wheel adapter, 1 pcs
Steering shaft extension, 1 pcs
Top steering bracket, 1 pcs
Screws for top steering bracket, 4 pcs
Flat washer for steering wheel, 1 pcs
1701 - 009 - 14.07.2023
Lock washer for steering wheel, 1 pcs
Seat, 1 pcs
Hex bolt for the seat, 2 pcs
Flat washer for seat, 2 pcs
To install the steering wheel
1. Install the steering shaft extension (A) on the
steering shaft (B).
K
J
I
H
G
2. Put the top steering bracket (C) onto the steering
shaft extension until it is flat against the dashboard.
3. Install the 4 screws (D) with a screwdriver but do not
tighten the screws in this step.
4. Tighten the 4 screws with your hand until they are
flat against the top steering bracket.
5. Use a screwdriver to tighten the screws 90° more.
CAUTION:
screws too much.
6. Install the shaft cover (E). Make sure that the guide
tabs in the shaft cover are in the correct positions.
7. Remove the steering wheel adapter (F) from the
steering wheel (G).
F
A
C
D
E
B
Do not tighten the
11