Werbung
Verfügbare Sprachen
Verfügbare Sprachen
TROUBLESHOOTING
CAUTION! Opening the housing of the device without a prior contact with a manufacturer's service voids the warranty. If you suspect a failure that requires
the housing to be opened, contact manufacturer's service.
Opis błędu
-----
Safety key issue
E01
The computer does
not work
E02
The motor does not
operate
E03
The computer failed to
detect speed sensor
signal for 15 seconds
E04
Communication error
E05
Overload error
E06
Explosion-Proof
Protection. Incorrect
power supply
E07
Nothing is displayed
E08
EEPROM driver error
E09
The controller is in an
inclined position
E10
Transient current
protection
E11
Voltage is too high
E13
Communication error
between the meter
and the controller. The
counter is not
receiving a signal from
the drive.
E14
Voltage is too low
The device does not
work
The running belt does
not move smoothly
The running belt is
skewed
Możliwe przyczyny
The safety key is not connected.
The computer is damaged.
The computer is incorrectly connected.
The signal cable is broken or insulation is worn
The computer is damaged
The connection between the control board and the
computer is blocked
Incorrect supply voltage
Incorrect connection of the motor cable
The controller is damaged
Sensor connection incorrect
Sensor plug connection incorrect
Sensor failure
Incorrect connection or damage to the wires.
Motor failure
Too low rated current in the controller.
Current exceeds the rated value
Supply voltage too low
Short circuit
The safety key is out
The driver is broken.
The device is not placed on a flat surface.
Incorrect installation of the driver.
Incorrectly mounted engine.
The transmission part of the treadmill is blocked.
Check if the AC power is above 270 VAT or it is unstable. If so, stop using the treadmill and report it malfunction.
Damaged wires between the meter and the
controller.
Incorrectly connected socket.
Check if the AC power is lower than 160VAC or it is
unstable. If so, please stop using the product and report
malfunction.
No power
The safety key is out
Short circuit
The ON/OFF switch is not on
The running belt is not lubricated enough
The running belt is too tense
The running belt is too loose
The drive belt is too loose
Rozwiązanie problemu
Connect the safety key correctly.
Contact manufacturer's service.
Verify the connection of computer cables.
Verify plug connections. If it is correct and the problem
persists, contact the customer service of the
manufacturer's service.
Contact the manufacturer's service.
Contact the manufacturer's service.
Make sure the voltage is correct. If the problem persists,
contact the customer service of the manufacturer's
service.
Disconnect the cable and connect it again. If the problem
persists, contact manufacturer's service.
Contact the manufacturer's service.
Contact the manufacturer's service.
Verify plug connections. If it is correct and the problem
persists, contact manufacturer's service.
Contact manufacturer's service.
Contact manufacturer's service.
Make sure the motor has not burnt out. If not, disconnect
the treadmill from the mains and reconnect it. If the
problem persists, contact manufacturer's service.
Replace the controller. Contact the manufacturer's
service.
Make sure the weight of the user does not exceed the
maximum value for the device.
Connect the device to the correct voltage.
Contact manufacturer's service.
Insert the safety key.
Contact manufacturer's service.
Move device to flat, stable surface, then restart.
Contact manufacturer's service.
Contact manufacturer's service.
Contact manufacturer's service.
Contact manufacturer's service.
Contact manufacturer's service.
Connect the device to a power source.
Insert the safety key.
Contact manufacturer's service.
Turn the device on.
Lubricate the running belt as per the manual.
Adjust and centre the running belt as per the manual.
Adjust and centre the running belt as per the manual.
Contact the manufacturer's service.
EN
18
Werbung
