GreenWorks GD24CS30 Bedienungshandbuch Seite 234

EN
1 DESCRIPTION
1.1 PURPOSE
The machine is used to
• drive long deck screws when you assemble a deck
• drive carriage bolts into deck posts
• drive screws into block walls and concrete
• drive screws into metal studs
1.2 OVERVIEW
Figure 1.
Coupler
1
LED work light
2
Switch trigger
3
2 SAFETY
Make sure that you do/obey all safety instructions.
Refer to Safety Manual.
3 INSTALLATION
3.1 UNPACK THE MACHINE
Make sure that you correctly assemble the machine before
use.
• If the parts are damaged, do not use the machine.
• If you do not have all the parts, do not operate the
machine.
• If the parts are damaged or missing, speak to the service
center.
1. Open the package.
2. Read the documentation in the box.
3. Remove all the unassembled parts from the box.
4. Remove the machine from the box.
5. Discard the box and package in compliance with local
regulations.
3.2 INSTALL THE BATTERY PACK
Figure 2.
Speed selection
4
Bit storage
5
Reversing button
6
WARNING
WARNING
WARNING
English
• If the battery pack or charger is damaged, replace the
battery pack or the charger.
• Stop the machine and wait until the motor stops before
you install or remove the battery pack.
• Read, know, and do the instructions in the battery and
charger manual.
1. Align the lift ribs on the battery pack with the grooves in
the battery compartment.
2. Push the battery pack into the battery compartment until
the battery pack locks into place.
3. When you hear a click, the battery pack is installed.
3.3 REMOVE THE BATTERY PACK
Figure 2.
1. Push and hold the battery release button.
2. Remove the battery pack from the machine.
3.4 INSTALL THE BIT
Figure 3.
1. Push reversing button in the center position to lock the
switch trigger.
2. Move the coupler forward and hold in position.
3. Put bit straight into coupler.
4. Release the couple.
Use only impact quality bits with a locking groove.
Make sure that you attach the bit tight in the coupler before
you use the machine.
3.5 REMOVE THE BIT
Figure 3.
1. Push reversing button in the center position to lock the
switch trigger.
2. Move the coupler forward and hold in position.
3. Pull the bit straight out of the coupler.
4 OPERATION
Always wear eye protection.
Do not use any attachments or accessories not
recommended by the manufacturer of this product.
4
WARNING
NOTE
WARNING
WARNING
WARNING