Sony Super Trinitron KV-28WF1D Bedienungsanleitung Seite 40

NOTICE FOR CUSTOMERS IN THE UNITED KINGDOM
A moulded plug complying with BS1363 is fitted to this equipment for your safety
and convenience.
Should the fuse in the plug supplied need to be replaced, a5 AMP fuse approved by
ASTA or BSI to BS 1362 (i.e. marked with @ or Y) must be used.
When an alternative type of plug is used it should be fitted with a5 AMP FUSE,
otherwise the circuit should be protected by a5 AMP FUSE at the distribution board.
If the plug supplied with this equipment has a detachable fuse cover, be sure to refit it
after you change the fuse. Never use the plug without the fuse cover. If you should
lose the fuse cover, please contact your nearest Sony service station.
How to replace the fuse
Open the fuse compartment with a blade screwdriver, and replace the fuse.
IMPORTANT
If the plug supplied is not suitable for the socket outlets in your home, it should be cut
off and an appropriate plug fitted in accordance with the following instructions:
The wires in this mains lead are coloured in accordance with the following code:
Blue: Neutral
Brown: Live
As the colours of the wires in the mains lead of this apparatus may not correspond
with the coloured markings identifying the terminals in your plug, proceed as
follows: The wire which is coloured blue must be connected to the terminal which is
marked with the letter N or coloured black. The wire which is coloured brown must
be connected to the terminal which is marked with the letter L or coloured red. Do not
connect either wire to the earth terminal in the plug which is marked by the letter E or
by the safety earth symbol + or coloured green or green and yellow.
WARNING
To prevent shock hazard, do not insert the plug cut off from the mains lead into a
socket outlet. This plug cannot be used again and should be destroyed.