Teesa SMOOTH TOUCH TSA5013 Bedienungsanleitung Seite 17

Owner's manual
Prior to first use, please fully charge the battery.
1. Make sure the appliance is turned off.
2. Make sure the appliance is placed:
• on flat surface,
• in a place with easy access to the power supply socket.
3. Open the rubber plug at the bottom of the motor unit.
4. Connect one end of the included USB cable to the USB-C socket, then connect the
other plug to the AC charger and then to the power outlet.
5. During charging, LED indicator flashes blue.
6. When charging is complete, LED indicator is on.
7. When charging is complete, disconnect the appliance from the power outlet.
Notes:
• Use only the included USB cable to charge the appliance.
• The appliance cannot be started during charging and it is forbidden to press the ON/
OFF button when the appliance is being charged.
• Fully charge the battery after each use and store the device fully charged.
1. Apply selected window cleaning agent or water on the surface to be cleaned and clean it.
Notes:
• Use only on wet, smooth surfaces such as glass, mirrors, tiles etc. Do not use the
appliance on the rough surfaces as this may damage the rubber squeegee.
• To clean the selected surface you can use the spray bottle with the cloth attached.
Make sure the bottle is filled with the selected window cleaning agent or water. Set
the tip of the spray head to the selected position: STREAM (foam) or SPRAY (water
mist). Spray the surface to be cleaned. Finally, use the cloth to clean the surface.
• To clean the surface you can use TEESA cleaning supply.
2. Turn on the window vacuum cleaner by pressing the ON/OFF button. Blue LED is on.
3. Place the rubber lip of the appliance on the surface to be cleaned and using light
pressure pull it from the top to the bottom across the surface. Repeat this step until the
surface is completely clean.
Note: Avoid sucking in dust and dirt.
4. If the maximum fill level (marked "MAX") of the water tank has been reached, the tank
must be emptied.
Note: It is recommended to empty the tank before the maximum water level has been
reached. Otherwise, small amounts of water may get into the ventilation system and
damage the appliance.
5. To empty the water tank, first turn off the appliance.
6. Then pull the water tank plug and pour out dirty water.
CHARGING
OPERATION
17
EN