VONROC MS501AC Bersetzung Der Originalbetriebsanleitung Seite 14

EN
Mounting the saw blade
When fitting the saw blade, make sure that
the cutting direction of the teeth (arrow
direction on the saw blade) matches the
direction of the arrow on the guard (4).
When fitting the saw blade (6), check to see
that it turns freely in the kerf plate (13) in
both 0° and 45° angle settings.
1. Clean the saw blade and all clamping parts to
be assembled.
2. Loosen the retaining bolt (40) using a philips
headed screwdriver as shown on figure G1;
WARNING! Do not fully remove the retaining bolt
(40), only loosen it.
3. Fold the retracting protective guard (5) upwards
until the clamping bolt (42) can be accessed
freely, as shown on figure G2;
4. Insert the hex key into the clamping bolt (42).
The retracting protective guard (5) can be
released, it will fold onto the hex key.
5. Mount the clamping flange (41). Ensure the
flat sides of the clamping flange correspond
with the flat sides of the blade shaft. Also make
sure the convex side of the clamping flange is
mounted to the outside.
6. Mount the clamping bolt (42) and turn it using
the hex key whilst at the same time pressing
the spindle lock (43), until it engages.
7. Firmly hold the spindle lock (43) and fasten the
clamping bolt (42) by turning it anti-clockwise.
Dust extraction (fig. A, B, W, X)
Provide good ventilation at the workplace.
Wear dust protection.
The dust from materials such as lead paint and
some types of wood can be harmful to your health.
Breathing in this dust can cause allergic reactions
and/or cause respiratory illnesses for the user or
people in the near vicinity. Certain dusts, such as
oak or beech dust, are classified as carcinogenic,
especially in conjunction with wood treatment
additives (chromate, wood preservative). We stron-
gly advise to use a dust extraction system that is
suitable for the material wherever possible.
14
Avoid dust accumulation at the workplace.
Dust can easily ignite.
The dust extraction system can be blocked by dust,
chips or fragments of the workpiece. Thus, it must
be cleaned regularly. To do so:
1. Disconnect the mains plug from the power supply.
2. Wait until the saw blade has come to a complete
stop.
3. Remove any blockage if necessary
Mounting the dust bag (Fig. W)
Press in the clamp of the dust bag (26) and slide
it onto the dust outlet (28) on the back of the ma-
chine. The dust bag stays in place when releasing
the clamp.
Connecting a vacuum cleaner (Fig. X)
The dust extractor must be suitable for the
material being worked.
When vacuuming dry dust that is especially
detrimental to health or carcinogenic, use
a special dust extractor.
A vacuum cleaner hose can be connected to the
dust outlet (28). To do so, simply connect the vacu-
um hose to the dust extraction spout.
4. OPERATION
Before you turn on the machine, always
check that the saw blade is fitted correctly.
The blade must turn smoothly.
Always check the protective guards before
use.
For all cuts, it must first be ensured that the
saw blade at no time can come in contact
with the fence, workpiece clamp or other
machine parts. Remove any mounted
auxiliary stops or adjust them accordingly.
Supporting the workpiece (fig. H)
Workpieces must always be properly supported.
The table extensions (10) can be extended left and
right to support a workpiece. To do so:
1. Loosen the locking bolt for table extension (34);
2. Move the table extension (10) to the desired
position;
WWW.VONROC.COM