Coccolle Mago Bedienungsanleitung Seite 12

EN
Adjusting the anti-rebound bar
The anti-rebound bar has two positions: reclined and upright. A forward-facing
mounted car seat can only use the upright position. Rotate the seat lateral
facing. Pull up anti-rebound bar button then adjust the position of anti-rebound
bar.
Rotating the car seat
Pull the rotation button at the same time to rotate seat to the intended direction.
(fig.15,16)
When the seat rotates is fixed in the desired direction, the rotation button will
bounce back and make click sound. Then try to rotate seat to make sure seat is
locked. (fig.17)
Installation of the isofix
If your vehicle is not equipped with the isofix insert guides as standard, clip the
two insert guides which are included with the car seat.
On both sides of the car seat press the isofix release button and pull out the
isofix connectors in longest position (fig.19,20). Slide the two isofix connectors
firmly into the insert guides until the isofix connectors engage with a clicking
noise on both sides. The isofix buttons must turn green on both sides (fig.21,22).
Push the child car seat towards the backrest of the car's seat applying firm,
even pressure on both sides. Shake the child car seat to make sure it is safely
attached and re-check the green safety buttons to make sure that both sides are
completely green (fig.23).
Removal of the isofix
Push the child seat towards the backrest firmly (fig24). At the same time press
the isofix button and pull back isofix connectors (fig.25).
Support leg installation
Pull the support leg away from the bottom of the seat until it is fully extended.
Push both adjustment buttons and pull out the support leg until it rests firmly on
the floor of the vehicle. Make sure the indicator on the support leg must turn
green, the bottom of the car seat does not lift up from the surface of the vehicle
seat and two adjustment buttons must be engaged.
Removal and installation of the safety harness
Loosen the press studs on the backrest and fold the upper half of the cover
upwards and the lower half downwards (fig.30). Loosen the 5-point harness on
the child car seat as far as possible. Then open the buckle (fig.29). Open the
two shoulder pads by the Velcro fasteners on the side. Push the Velcro strip of
the two opened shoulder pads under the backrest cover and attach it to the
fleece strip provided (fig.31). Insert the buckle tongues in the recess provided on
the inside of the backrest (fig.32). Open seat cover and fold the cover forwards,
pull the harness buckle out of the cover (fig.33). Stow the harness buckle in the
recess provided (fig.34). Close the two press studs and put back on the seat
cover (fig.35). to refit the harness, simply follow the steps in the opposite order.
Make sure the belt is not twisted.