Coccolle Mago Bedienungsanleitung Seite 14

EN
Installing the isofix connectors (fig.49).
Have your child sit down in the child car seat. Adjust headrest in proper height.
Pull out the vehicle seat belt and guide it in front of your child to the vehicle seat
buckle. Engage the buckle tongue in the vehicle seat buckle (fig.50). Caution!
The vehicle seat belt buckle must not be positioned in the lower belt guide.
Place the diagonal seat belt section and lap belt section on the side of the
vehicle seat belt buckle in the lower belt guide (fig.51). Place the lap belt section
on the other side of the child car seat in the lower belt guide (fig.52). Caution!
The lap belt section must lie as low as possible over your child's hips on both
sides.
For child stature 100-150 cm installation, this child car seat also can use vehicle
belt only, it has been tested for it. If you want to used only vehicle belt
installation, just skip the Isofix connectors relative content. Guide the diagonal
belt section into the belt holder and it is not twisted (fig.53).
Cleaning and maintenance
The cover can be removed and washed. Please observe the instructions on the
washing label of the cover. Loosen the press studs at the back of the headrest
and remove the cover of headrest. Loosen the press studs and unzip the back
of seat cover. Pull forward and remove seat cover. To refit the cover simply
follow the steps in the opposite order.