Coccolle Mago Bedienungsanleitung Seite 13

EN
Installation and removal of the side impact shield
This car seat has been tested and approved to offer optimum side protection
without side impact shield. The side impact shield is optional for extra side
protection, but mind the fact that when used it may not fit in all approved
vehicles. The side impact shield should be installed at the side which is close to
vehicle door. To install, insert the clip-on side impact shield onto seat side wing
were marked with two dents. Pull out the hook by pressing the button on the
side impact shield and hook into the hole on the seat side wing. To remove,
press the button then unhook from seat side, slide out the side impact shield
from seat side wing.
Rearward-facing installation 40-105cm (born to approx. 4 Years, ≤ 18 kg)
Notice: The infant cushion protects your child. It needs to be used up to the
height of 75 cm. Pull away support leg from seat bottom, for more leg space
adjust anti-rebound bar in a recline position. Rotate seat to rearward facing (fig
38) and adjust the seat in most reclined position (fig 39). Place the seat in a
direction opposite to the direction of travel (fig.40). Have your child sit down in
the child seat. Adjust headrest in proper height (see section 4.3), adjust harness
and lock the buckle, then tighten the harness (fig. 42).
Forward facing installation 76-105cm (15 months to approx. 4 years, ≤ 18
kg)
Important! Do not use forward facing before the child has not reached the age of
15 months.
Pull away support leg from the seat bottom and adjust the rebound bar in upright
position. Rotate the seat to forward facing position (fig.43). Place the seat in a
direction facing to travel (fig.44). Install the isofix connectors. Install support leg
(fig.45). Have your child sit down in the car seat. Adjust the headrest in a proper
height (see section 4.3), adjust the harness and lock the buckle, finally tighten
the harness. (fig. 46)
Forward facing installation 100-150cm (approx. 3 years to 12 years)
Remove the safety harness when your child has reached a stature between 100
and 150cm.
Make sure that the support leg is stored on the bottom of the seat and adjust
anti-rebound bar in upright position. Rotate seat to forward facing position. Place
the seat in a direction facing to travel (fig47,48). There are two options to install:
only using the vehicle 3 point belt or using the vehicle 3 point belt together with
isofix connectors.
Caution! In both options you don't use the support leg.