Swim & Fun Santorini XL Bedienungsanleitung Seite 55

7. Installing the liner
Note
The warranty for the pool liner is only valid when a protective ground cover is placed un-
der the pool.
The pool liner is the most important and most delicate part of the pool. When opening the liner packaging, it
is therefore important that you never use a knife or other sharp instrument. The liner should be kept separate
when assembling the pool in order to avoid any accidental damage to the liner caused by tools or metal edg-
es.
Several people are needed to complete the installation. It is a good idea to set out the liner and allow it to be
heated by the sun's rays before being unfolded – it makes the material more flexible and easier to work with.
The outdoor temperature should be between 20 and 25 degrees when handling the liner. Never install a very
cold liner or a liner whose temperature exceeds 25 degrees as different temperatures can easily warp the
flexible liner material. This can affect the results of the assembly.
Check that there are no holes in the liner. Then spread the liner out as much as possible from the middle of
the pool and all the way around the pool wall.
Note: Do not wear shoes when spreading the liner
from the middle out to the pool wall!
The uppermost part of the liner sides is held in place
temporarily along the edge of the pool wall with
clothes pegs.
Check that the seam between the liner's bottom and sides is uniform along the length of the solid masonry
sand layer.
Check the diameter of your pool once more and at this point fill it with a maximum of 2 cm of water in the
bottom of the pool. No more than that! Adjust/pull the liner the entire way around the pool so that wrinkles
are smoothed out as much as possible on the bottom and sides. This is best done by standing in the middle
of the pool and smoothing the liner outward toward the sides of the pool. Please note that this can no longer
be corrected once the pool is filled with more water!
Once the wrinkles in the bottom of the pool have been reduced, smooth out the wrinkles along the sides.
Make sure that the liner is not pulled too tightly up over the edge of the pool before the pool is filled. It is still
possible to tighten the liner slightly at a water level of approx. 30 cm, so wait to attach the top rails over the
edge of the pool.
You can now fill the pool with more water. In the meantime, you should ensure that the pool does not lose its
round shape. Remove the clothes pegs and attach the top rail in place on the edge of the pool. The top rails
are assembled just like the bottom rails and they should rest firmly in place the entire way around. The water-
line should not be higher than approx. 15 cm from the edge.
Note
Excess liner must not be cut off to prevent the liner from becoming too short after use of the pool.
MV-1944/1945-08-2022 . © Alle rettigheder forbeholdes Swim & Fun A/S
UK
Clothes pegs
55