Werbung
Verfügbare Sprachen
Verfügbare Sprachen
BATTERIES INSTALLATION AND REPLACEMENT
This equipment employs 4 AA 1.5 V alkaline batteries for its
operation. The gun is supplied without these batteries
installed, follow the procedure described below for
installation or replacement:
1. Remove the rubber cover (1) and then loosen the
screws (2) and remove the battery housing cover (3).
2. Install the supplied batteries (4) or equivalent batteries
(see technical specifications) according to the polarity
indicated in the battery compartment (5).
3. Place again the cover (3) and tighten the screws (2).
4. Finally, mount the rubber protector (1).
OVERVIEW
1
Display
1.1
Partial counter
1.2
Total/trip counter
1.3
History mode of transactions activated (H)
1.4
Battery level indicator
1.5
Partial counter unit
1.6
Totalizer unit
2
Buttons for setting preset quantity
3
Preset mode button
4
ON/RESET button
5
Select button
(adittional functions depending on menu)
The control gun turns off automatically after 30 seconds of
inactivity to save energy. To switch on again the display
press the ON button (4).
The display shows the partial counter (1.1) on the top row
and by pressing the power button (4) the total counter or
the trip counter (resettable totalizer) is shown alternately on
the bottom line.
To reset the trip counter, press and hold the ON/RESET
button until it resets to zero.
SAMOA Industrial, S.A. · Pol. Ind. Porceyo, I-14 · Camino del Fontán, 831 · 33392 - Gijón - Spain · Tel.: +34 985 381 488 · www.samoaindustrial.com
1
5
1.1
1.3
1.4
4
3
EN
3
2
4
5
1
1.5
1.6
1.2
2
5
3
R. 03/22 896 846
Werbung
