Werbung
Verfügbare Sprachen
Verfügbare Sprachen
EN
INTRODUCTION
WARNING: This unit is intented for professional use.
!
Reada all the instructions in this manual prior to use.
- Only use the unit for the purposes for which it is intended.
- This unit has not been approved for use in commercial
transactions.
- Do not alter or modify the unit.
- It is mandatory to respect the polarity of batteries and follow
its order of placement as indicated in the batteries cover.
- If a leakage is detected in the batteries protect your eyes
and skin. Cover the batteries housing with a cloth before
INSTALLATION
Mount the non-drip nozzle with the ½" bonded seal
provided. Tighten the nozzle nut (1a) firmly to prevent
leakage. If using a rigid nozzle, first tighten the nut (1b),
place in proper position the nozzle tuve (2) and then tighten
the nut (3) to secure it.
Before connecting the hose to the gun, you must assemble
the swivel cover (4) into the hose (5). This cover is compatible
with ½" hoses. Depending on the type of hose end (6) it may
be necessary to open the groove at the end of the swivel
cover to allow it to enter through the hose fitting.
To connect the hose, hold the hose end (6) stationary while
turning the swivel end (7) of the swivel until the desired
tightness is achieved.
2
896 846 R. 03/22
SAMOA Industrial, S.A. · Pol. Ind. Porceyo, I-14 · Camino del Fontán, 831 · 33392 - Gijón - Spain · Tel.: +34 985 381 488 · www.samoaindustrial.com
opening it to avoid that acid get sprayed onto your skin
or eyes. If acid should spray into your eyes, rinse
immediately with clear water for several minutes.
Consult a doctor immediately afterwards
- Do not mix different battery brands.
- Do not mix new batteries with old ones.
2
3
1a
7
1b
1
1
6
4
5
Werbung
