Werbung
Verfügbare Sprachen
Verfügbare Sprachen
EN
28
•
Open the glass plate (1) and remove the metal grease filter (2-3).
•
Mark the four mounting holes on the inside of the hood.
•
Remove the extractor hood again. Drill four 8 mm diameter holes in the wall
at the marked locations and insert the dowels into the holes.
•
Hang the extractor hood on the wall bracket and fasten it to the dowels with
the screws from the inside of the hood (4).
•
Connect the exhaust hose to the outlet (5).
Chimney installation
Exhaust air
Upper part of the
chimney (inside)
•
Slide the upper chimney section into the lower chimney section. Pay attention
to the position of the ventilation slots - depending on the use for exhaust or
recirculation (see illustration).
•
Attach the lower wall bracket to the lower part of the chimney.
Circulating air
Wall mount
Lower part
of chimney
(outside)
Werbung
