Herunterladen Diese Seite drucken

Electrolux IK33110 Benutzerinformation Seite 43

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Problem
The temperature in the
appliance is too low/
high.
The temperature in the
refrigerator is too high.
Upper or lower square is
shown in the tempera-
ture display.
dEMoappears on the Dis-
play.
Replacing the lamp
The appliance is equipped with a longlife
LED interior light.
Only service is allowed to replace the light-
ing device. Contact your Service Center .
Closing the door
1. Clean the door gaskets.
TECHNICAL DATA
Dimension of the recess
Voltage
Frequency
The technical information are situated in the
rating plate on the internal left side of the
appliance and in the energy label.
INSTALLATION
Read the "Safety Information" carefully
for your safety and correct operation of
the appliance before installing the
appliance.
Possible cause
The temperature regulator is not
set correctly.
The door is not closed correctly.
The product temperature is too
high.
Many products are stored at the
same time.
There is no cold air circulation in
the appliance.
An error has occurred in meas-
uring the temperature.
The appliance is in demonstra-
tion mode (dEMo).
Height
Width
Depth
Set a higher/lower temperature.
Refer to "Closing the door".
Let the product temperature de-
crease to room temperature be-
fore storage.
Store less products at the same
time.
Make sure that there is cold air
circulation in the appliance.
Call your service representative
(the cooling system will continue
to keep food products cold, but
temperature adjustment will not
be possible).
Keep pressed approximately 10
sec. the OK button since a long
sound of buzzer is heard and the
Display shut off for a short while:
appliance start works regularly.
2. If necessary, adjust the door. Refer to
"Installation".
3. If necessary, replace the defective door
gaskets. Contact the Service Center.
1780 mm
560 mm
550 mm
230-240 V
50 Hz
Positioning
Install this appliance at a location where the
ambient temperature corresponds to the
electrolux 43
Solution

Werbung

loading

Diese Anleitung auch für:

Ik331010