led2work SYSTEMLED Betriebsanleitung Seite 10

2 | For safe operation
The operating parameters of the LED light specified on the type plate must correspond to the supply parameters of the
connection.
Operate the light only in a mounted status.
3 | Safety information
4 | Assembly / Mounting
Check the LED light before installation to ensure it is complete and shows no signs of damage. Do not use the light or
accessories if they are damaged, as there is a risk of injury.
The LED light comes fully assembled. On the backside of the light is a T-slot for a mounting via T-nuts 10, M6. As option
there are this mounting accessories:
Mounting kit, flat, for T-slot, with ESD insulation (Electro Static Discharge), pair
Mounting kit, pivotable, for T-slot and movable mounting, pair
Mounting kit, one pair of T-Slot Nuts with cheese-head screws
10 | BA SYSTEMLED . BA 01/2024
Under no circumstances may the light be covered with cloths, foils or similar. Object
distance the light-emitting surface should be at least 10 cm (3.94").
The light may only be connected load-free, as hot plugging can destroy the LED chips.
During the operation of the light in a 220-240V power supply net, it could be the cause,
that machines (induction perpetrators) inside the same power supply net cause interferen-
ce spikes at start. This deviations may only 10% max.
Installation of electrical equipment may only be carried out by qualified electricians.
Follow the five safety rules according to DIN VDE 0105. Failure to do so may result
in damage to the LED light, as well as fire or other hazards.
Danger of electric shock!
Disconnect before working on the device or load. Ensure to disconnect all circuit breakers
that supply dangerous voltages to the device or load, when doing so. Even when the
device is switched off, the load is not galvanically isolated from the mains.
Only use the device if it is completely free of faults, and with safety and awareness in
mind. If warnings or symbols are attached to the light, they must not be removed.
When mounting the light, make sure that the luminaire is fastened securely and stably. If
the light falls down, its weight poses a risk of injury!
Product no.
240400-01
240400-02
240400-03