Atlas Copco PowerMACS TC-4000P Sicherheitshinweise Seite 3

PowerMACS TC-4000P
Declarations
Notice
Many events in the operating environment may af-
fect the tightening process and shall require a vali-
dation of results. In compliance with applicable
standards and/or regulations, we hereby require
you to check the installed torque and rotational di-
rection after any event that can influence the tight-
ening result. Examples of such events include but
are not limited to:
• initial installation of the tooling system
• change of part batch, bolt, screw batch, tool,
software, configuration or environment
• change of air- or electrical connections
• change in line ergonomics, process, quality
procedures or practices
• changing of operator
• any other change that influences the result of
the tightening process
The check should:
• Ensure that the joint conditions have not
changed due to events of influence.
• Be done after initial installation, maintenance
or repair of the equipment.
• Occur at least once per shift or at another suit-
able frequency.
EU DECLARATION OF CONFORMITY
We, Atlas Copco Industrial Technique AB,
S-105 23 STOCKHOLM SWEDEN, declare under
our sole responsibility that the product (with name,
type and serial number, see front page) is in con-
formity with the following Directive(s):
2011/65/EU, 2014/30/EU, 2014/35/EU
Harmonized standards applied:
EN 61010-1:2010, EN 61800-3:2004 + A1:2012,
EN ISO 13849-1:2008 Category 3 PL d
Authorities can request relevant technical informa-
tion from:
Product Compliance Manager, Atlas Copco Indus-
trial Technique AB, S-105 23 Stockholm Sweden
Stockholm, 5 October 2017
James McAllister, Managing Director
Signature of issuer
© Atlas Copco Industrial Technique AB - 9836 4061 00
WEEE
Information concerning Waste of Electrical and
Electronic Equipment (WEEE):
This product and its information, meets the re-
quirements of the WEEE Directive (2012/19/EU),
and must be handled in compliance with the direc-
tive.
The product is marked with this symbol:
Products with the symbol of a crossed out wheelie
bin with a single black line underneath, indicates
that parts within the product must be handled in
compliance with the WEEE Directive. The entire
product, or the WEEE parts, can be sent to your
"Customer Centre" for handling.
Batteries are marked with the symbol of a crossed
out wheelie bin without a single black line under-
neath. The battery must be recycled either accord-
ing to local regulations or sent to your "Customer
Centre" for handling.
Safety
WARNING Risk of Property Damage or Se-
vere Injury
Ensure that you read, understand and follow all
instructions before operating the tool. Failure to
follow all the instructions may result in electric
shock, fire, property damage and/or severe bod-
ily injury.
Read all Safety Information delivered to-
►
gether with the different parts of the system.
Read all Product Instructions for installa-
►
tion, operation and maintenance of the dif-
ferent parts of the system.
Read all locally legislated safety regulations
►
regarding the system and parts thereof.
Save all Safety Information and instructions
►
for future reference.
Safety Information
3