Before Using; Disassembly; Instructions For Use - Create COTTON CANDY MAKER Bedienungsanleitung

Before using the machine for the first time, unpack and disassemble the product for cleaning.
D ISAS SE MB LY
1. Remove the lock ring and rim by carefully removing the lock ring.
2. Remove the canister by rotating it until the plastic tabs disengage from
the metal locking tabs on the motor unit. Then remove the container by
carefully pulling it upwards.
3. Remove the extractor head by pulling it up.
4. Remove the extractor head.
5. Follow the Care and Maintenance instructions.
6. After cleaning, assemble the parts in the reverse order of the instruc-
tions described above.
NOTE: Take special care that the canister is securely locked into position
and that the plastic tabs on the canister engage the metal locking tabs on
the motor unit. Make sure the slot in the puller head is precisely aligned
with the motor drive shaft pin when attaching.
Warning: Puller head fits over metal locking tab.
1. Place the cotton candy maker on a level surface and plug it into an outlet.
2. Press the ON button of the machine and let it heat up for 5 minutes.
3. Turn off the machine and let the extractor head come to a complete stop.
4. Use the included measuring spoon to measure out a level tablespoon of sugar and pour it
into the center of the extractor head (If you want to use hard candies, evenly place two or
more hard candies in the center of the extractor head).
• The hard candies must be placed evenly, otherwise the extractor head will vibrate while
running, and the machine will make different sounds.
• The size of the hard candy should be less than 20mm in width and the thickness should
not exceed 10mm. The maximum quantity that the machine can process is 5 or 6 pieces
at one time.
E NGL I SH
8

BEFORE USING

INSTRUCTIONS FOR USE