System Settings - Pioneer MVH-390BT Bedienungsanleitung

Menu Item
SUB.W CTRL*2*3
Cut-off frequency: [50HZ],
[63HZ], [80HZ], [100HZ],
[125HZ], [160HZ], [200HZ]
Output level: [–24] to [+6]
Slope level: [–12], [–24]
BASS BOOST
[0] to [+6]
HPF SETTING
Cut-off frequency: [OFF],
[50HZ], [63HZ], [80HZ],
[100HZ], [125HZ], [160HZ],
[200HZ]
Slope level: [–12], [–24]
SLA
[+4] to [–4]
*1 Not available when [SUB.W/SUB.W] is selected in [SP-P/O MODE] in the INITIAL settings
(page 6).
*2 Not available when [REAR/REAR] is selected in [SP-P/O MODE] in the INITIAL settings
(page 6).
*3 Not available when [OFF] is selected in [SUB.W].

SYSTEM settings

You can also access to these menus when the unit is turned off.
18
En
Description
Only frequencies lower than those in the
selected range are output from the
subwoofer.
Select the bass boost level.
Only frequencies higher than the high-pass
filter (HPF) cutoff are output from the
speakers.
Adjust the volume level for each source
except FM.
Each of the below combinations are set to
the same setting automatically.
• When making a USB connection, set USB,
iPod, ANDROID, SPOTIFY, and APP.
• When making a Bluetooth connection,
set BT AUDIO, ANDROID, SPOTIFY, and
APP.
Menu Item
LANGUAGE
[ENG](English),
[РУС](Russian), [TUR](Turkish)
CLOCK SET
12H/24H
[12H], [24H]
AUTO PI
[ON], [OFF]
AUX
[ON], [OFF]
BT AUDIO
[ON], [OFF]
SPOTIFY
[ON], [OFF]
PW SAVE*
[ON], [OFF]
BT MEM CLEAR
[YES], [NO]
Description
Select the language to display the text
information from a compressed audio file.
Set the clock (page 5).
Select the time notation.
Search for a different station with the same
programming, even if using a preset
station.
Set to [ON] when using an auxiliary device
connected to the unit.
Set the Bluetooth signal on/off.
Set to [ON] when using the Spotify
function.
Reduce the battery power consumption.
Turning on the source is the only operation
allowed when this function is on.
Clear the Bluetooth device data (device list,
PIN code, call history, phone book, preset
phone numbers) stored in the unit.
[CLEARED] appears when data is
successfully deleted.