YATO YT-82818 Originalanleitung Seite 15

EN
OPERATION OF THE DEVICE
Mounting the inserted tool
ATTENTION! All operations listed in this chapter should be performed with the disconnected supply voltage, the battery must be
disconnected from the tool!
During installation of the inserted tool equipped with sharp edges, be careful and use personal protective equipment, in particular
protective gloves.
The spindle has been adapted for insertion of inserted tools with an open socket, but, by applying the included adapter, it is also
possible to install the inserted tools with a closed socket.
Tools inserted with an open socket
Lift, and then turn for 180 degrees the lever of the quick installation mechanism (II).
Install the inserted tool which is designed for the selected type of work. Mount the inserted tool holder on the spindle handle so
that the work was as easy as possible, yet safe.
Attention! It is prohibited to assembly at the place, where the working part of the inserted tool (blade) would be directed towards
the tool operator.
Make sure, that the holes of the inserted tool are in line with the pins of the spindle handle (IV). Attention! It is forbidden to install
at places, where the inserted tool will be mounted with less than two pins.
Turn the lever of the quick installation mechanisms for 180 degrees, allowing the inserted tool to be mounted int spindle handle.
Push the lever of the quick installation, so as to protect it from accidental opening during its operation.
Insertion tools with a closed socket (V)
Make sure, that the quick-release lever is in its closed position.
Insert the inner fl ange of the spindle adapter. Mount the inserted tool on the spindle adapter so that the work was as easy as
possible, yet safe.
Attention! It is prohibited to assembly at the place, where the working part of the inserted tool (blade) would be directed towards
the tool operator.
Make sure, that the holes in the inserted tool are in line with the pins of the spindle handle. Attention! It is forbidden to install at
places, where the inserted tool will be mounted with less than two pins.
Install the outer fl ange of the spindle adapter, then tighten the whole set to the spindle using a screw, which is fi rmly and securely
tightened.
If the insertion tool is fi tted with a closed socket, you can not open the quick release lever and do not force it, because this can
cause damage to the tool spindle.
Installation of the abrasive sheet (VI)
If a grinding tool is to be the insertion tool, then before you proceed to operate the machine, it is required to install an abrasive
sheet. The attachment is equipped with a Velcro fastener to which the abrasive sheet must be fastened in such a manner that
the edges of the sheet are aligned with the edges of the attachment. In case of attachments with holes used to extract dust, it
is required to use abrasive sheets with holes. While attaching the sheet to the attachment, make sure the holes in the sheet are
aligned with the holes of the attachment.
Dust extraction
The tool is not equipped with an integral dust extraction system. In case external dust extraction systems are used, observe the
recommendations they are provided with.
Adjustments of the speed of oscillations (VII)
The tool is equipped with a rotational regulator of the speed of oscillations, which permits smooth adjustments within the range
indicated in the table. In order to adjust the speed of oscillation, move the handwheel to the desired position.
PREPARING FOR OPERATION
Disconnect the battery from the tool.
Before working with the tool, you should check whether the body enclosure, the battery and inserted tool are not damaged. If there
are any visible damages to the power tool is prohibited to operate it until the damages are removed!
Install the inserted tool which is designed for the selected type of work.
Wear eye protection, hearing protectors and working gloves.
Check whether the switch is in the "off " position. Then insert the battery into the power tool.
Adopt the proper body position, which is needed to maintain balance, and start the tool by its switch.
The tool is equipped with the lamp, which is illuminating the workplace. The light turns on automatically when the power tool is
started and turns off automatically when the power tool is turned off .
O R I G I N A L I N S T R U C T I O N S
15