Configuration Of The Receiver; Basic Settings; Factory Defaults - Medion MD 29292 Handbuch

Configuration of the receiver

Basic settings

The basic settings are done in the sub menu "Edit Settings" of the main menu, which can
be reached by pressing the MENU button twice.
To change the individual options in the under points of the settings menu use the /
buttons. As long as these options stem from a values list, this can be seen by pressing the
OK button. Numerical values can be directly entered using the number buttons.
Settings, which have been changed without saving, are marked green. When the receiver is
used for the first time and no settings have been made, the values will all appear green.
Changes to settings must be saved. Go to the heading "Save settings" in the settings menu
and press OK. Wait until the menu has disappeared, only then are the changes saved in the
memory, this may take a few seconds.
The individual options are clearly explained in the online help. Please read the chapter
"Installation" carefully to make the important settings.

Factory defaults

The function "Factory Defaults" in the "Edit Settings" menu resets all settings to the values
that are set during manufacturing.
Only models with satellite reception:
The factory defaults will not be saved automatically and will be lost when the receiver is
disconnected from power supply. Changes that were applied by the "Factory Defaults"
function are highlighted in green in the menus. To save the defaults the "Save settings"
function must be called.
Only models with cable or terrestrial reception:
The Factory defaults will be saved immediately and the channel list will be emptied.
53