cecotec Cumbia CAFELIZZIA 890 GRAY Bedienungsanleitung Seite 19

ENGLISH
1. PARTS AND COMPONENTS
1. Tank cover
2. Water tank
3. Steam knob
4. Control panel
5. Cup tray
6. Steam Tube
7. Drip tray
8. Filter for 1 coffee
9. Filter for 2 coffees
10. Filter holder
11. Portafilter
12. Measuring spoon and coffee tamper
13. Steam button
14. 2 espresso/double espresso button
15. 1 espresso button
16. Power button
Please note
The graphics in this manual are schematic representations and may not exactly match the
product.
2. BEFORE USE
• Take the product out of the box and remove all packaging materials, stickers, etc.
• Make sure all parts and components are included and in good conditions. If any visible
signs of damage are observed, contact Cecotec's Technical Support Service immediately.
First cleaning
• Fill up the water tank. The water level should not exceed the "MAX" mark in the tank.
• Insert the filter in the funnel and assemble the portafilter into place. Ensure the
portafilter is aligned with the lock drawing to ensure it is safely assembled. Fig. 2.
• Plug the device into a power supply. Make sure the steam selector is in the off position.
The machine will beep. The 1-coffee and 2-coffee light indicators will turn on and the
machine will start pre-heating.
• Once the 1-coffee and 2-coffee light indicators remain steady, press the 1-coffee button.
The machine will start the cleaning process.
36
CAFELIZZIA 890 ROSE_GRAY_DARK
Note
If you wish to carry out a more thorough cleaning cycle of the machine's inside, use a
descaling liquid or tablet with an anti-scale solution. Follow the instructions regarding the
water/descaler ratio for correct use of the product. Repeat this process only with water to
remove remains.
3. OPERATION
• Fill the water tank without exceeding the MAX mark. Use mineral water for better
maintenance of the device.
• Connect the coffee machine to a power supply and make sure the steam knob is set at
the off position. Turn on the coffee machine.
Espresso
While the machine preheats, place the desired coffee filter in the portafilter and fill it with
coffee powder. Use the measuring spoon/coffee tamper to pour and press down the coffee.1
tablespoon is equal to 1 coffee dose. Clean the excess coffee from the filter's edge.
Fig. 3.
Insert the portafilter in the device and lock it tightly.
Fig. 4.
Once the 1-coffee and 2-coffee light indicators switch from blinking to steady, press the
desired coffee button for the machine to brew 1 or 2 coffees.
Note
Make sure you have previously placed an appropriate cup or cups under the coffee spout.
Milk froth
• With the machine switched on and preheated, press the steam button. The steam
indicator light will flash and then remain steady when the preheating process is
complete.
• Pour milk into the container where you want to froth milk. Fill up 1/3 of the container.
• Recommendation:it is recommended to use cold whole milk for optimal results.
• Place an empty glass under the frother, turn the steam selector to the steam/water
position, and let the tube emit steam before frothing the milk. Once steam is emitted,
deactivate the steam function by returning the steam selector to the off position, insert
the 1-cm steam tube into the milk, and turn the steam selector slowly counterclockwise
until steam is produced.
Fig. 5.
ENGLISH
37
CAFELIZZIA 890 ROSE_GRAY_DARK