STIEBEL ELTRON DEL 18/21/24 SL electronic LCD Bedienung Und Installation Seite 34

InStaLLatIon
Installation
wall mounting bracket when replacing an appliance
When replacing an appliance, you can use an existing wall mount-
ing bracket of a Stiebel Eltron appliance (except for a DHF instan-
taneous water heater).
f Press the appliance over the threaded stud of the existing f
wall mounting bracket. When doing so, push through the soft
seal in the back panel of the appliance. If necessary, use a
screwdriver.
DHF replacement
f Reposition the threaded stud on the wall mounting bracket f
(the stud has a self-tapping thread).
f Rotate the wall mounting bracket 180° and mount it on the f
wall (the DHF logo is then turned towards the reader).
installation with offset tiles
20
2
1
1 Minimum contact area of the appliance
2 Maximum tile offset
f Adjust the wall clearance. Lock the back panel with the fixing f
toggle by turning it 90° clockwise.
34 | DEL SL electronic LCD
Pivoting appliance cover
You can rotate the appliance cover for undersink installation.
electr o nic comfor t
f Remove the programming unit from the appliance cover by f
pressing the locking hooks and taking out the programming
unit.
f Turn the appliance cover (not the appliance) and refit the f
programming unit, ensuring that all locking hooks click into
place. When clicking the locking hooks into place, make sure
you press against the inner side of the appliance cover (shad-
ed area).
f Plug the set value transducer cable into the PCB (see chapter f
"Commissioning / Initial start-up").
f Hook the appliance cover in at the bottom. Pivot it up to the f
back panel.
f Ensure the all-round seal of the back panel is firmly seated f
by pushing the cover gently forwards and back.
f Secure the appliance cover. f
operation with preheated water
By installing a central thermostatic valve you will limit the max-
imum inlet temperature (see chapter "Appliance description /
Accessories").
anti-scalding protection / temperature limit
2
1
1 Position 43: Maximum temperature setting 43 °C
2 Position 60: No temperature limit, for temperature setting
range, see chapter "Specification / Data table".
f Remove the appliance cover. f
f Slide the switch to the required position. f
f Fit the appliance cover. f
electr o nic comfor t
60
43
www.stiebel-eltron.com