STIEBEL ELTRON DEL 18/21/24 SL electronic LCD Bedienung Und Installation Seite 33

InStaLLatIon
Installation
water installation on finished walls
Suitable pressure-tested taps can be ordered as accessories.
1 Water plug
2 Pressure tap for finished walls
f Fit the water plugs with gaskets to seal the in-wall connec- f
tion. All pressure taps listed in the accessories are supplied
with plugs and gaskets as part of the standard delivery.
f Install the tap. f
f Place the lower section of the back panel under the tap con- f
nection pipes. Slide the lower section of the back panel into
place.
f Fit the connection pipes to the appliance. f
water installation for finished walls with solder / compression
fitting
With the solder fitting or compression fitting accessories you can
connect both copper and plastic pipes. For installation, prepare
the appliance cover, see chapter "Water installation on finished
walls, fitting the appliance cover".
The solder fitting with threaded fitting is suitable for 12 mm cop-
per pipes.
f Push the union nuts over the connection pipes. f
f Solder the inserts to the copper pipes. f
f Slide the lower section of the back panel under the tap con- f
nection pipes. Push the lower section of the back panel into
place.
f Fit the sealing elements on to the connection pipes. f
f Fit the connection pipes to the appliance. f
Note
Observe the tap manufacturer's instructions.
www.stiebel-eltron.com
water installation on finished walls, fitting the appliance cover
4
3
1
2
1
2
1 Back panel guides
2 Screw
3 Cover guides
4 Pipe aperture
f Cleanly break out the knock-out apertures in the appliance f
cover. If necessary, use a file.
Note
If the tap connection pipes are slightly offset, the appli-
ance can be sealed using the tabs on the cover guides.
f If the tap connection pipes are offset, do not fit any f
back panel guides.
f If installing tap connection pipes which are not offset, break f
off the tabs on the cover guides.
f Click the cover guides into place in the pipe apertures. f
f Position the back panel guides on the pipes. Push them to- f
gether. Then push the guides until they are resting against
the back panel.
f Secure the back panel at the bottom with a screw. f
installation of lower back panel with threaded fitting on
finished walls
You can install the lower back panel after fitting the taps.
2
1 Connection pieces delivered in the pack
2 Screw
f Cut open the lower back panel at the markings. f
f Fit the lower back panel by bending it out at the sides and f
guiding it over the pipes.
f Insert the connection pieces into the lower back panel from f
behind.
f Click the lower back panel into place. f
f Secure the lower back panel with a screw. f
1
DEL SL electronic LCD | 33