STIEBEL ELTRON DEL 18/21/24 SL electronic LCD Bedienung Und Installation Seite 25

opEratIon
Settings and displays
4. settings and displays
4.1 User interface
3
M1
2
1
1 Temperature selector
2 LED scalding risk indicator
3 Memory keys M1 and M2
4 Display
5 Temperature limit T max
display symbols
1
1 In the event of an appliance fault, a spanner appears
2 Segment display for temperature setting with °C
3 Performance bar, 10 - 100 %
4 Tmax, displayed when temperature limit is enabled
setting the temperature
2
M1
1
www.stiebel-eltron.com
4
M2
Tmax
5
2
3
4
M2
Tmax
3
1 Set temperature setting range 30 - 60 °C (without end-stop)
35 °C to 43 °C in 0.5 °C increments, other temperature ranges
in 1 °C increments
2 Call up preferred temperatures
3 Set the temperature limit
Memory keys M1 and M2 can each be assigned a preferred tem-
perature.
f Select a preferred temperature. f
f Press one of the M keys for 3 seconds to save the preferred f
temperature . The temperature is confirmed with 1x flashing.
Note
!
If the outlet temperature is not sufficiently high when the
draw-off valve is fully open and the temperature selector
is set to maximum, then more water is flowing through
the appliance than can be heated by the heating system
(working at maximum output).
f Reduce the water volume at the draw-off valve until f
the required temperature delivery is achieved.
4.2 temperature limit (child-proofing)
M1
The temperature limit can be individually set between 30 °C and
60 °C.
enabling the temperature limit (child-proofing)
f Press and hold the Tmax key for > 6 seconds. The set value f
display flashes and the current temperature limit is shown.
f The value for the temperature limit can be changed while f
the display is flashing. If no key is pressed for 10 seconds,
the display stops flashing and the value is stored. The display
then shows the set value and the Tmax symbol.
disabling the temperature limit (child-proofing)
f Press and hold the Tmax key for > 6 seconds. f
f The Tmax symbol on the display is no longer shown. f
inlet temperature information
If the inlet temperature is higher than the preferred temperature,
e.g. if water has been preheated by solar energy, the display alter-
nates between showing "hot" and the measured inlet temperature.
The LED scalding risk indicator also flashes.
M2
Tmax
DEL SL electronic LCD |
v
25