Herunterladen Diese Seite drucken

ICI Caldaie G350 MX Montage Und Bedienungs Anleitung Seite 11

Gas-vormisch-brenner

Werbung

REGELBEREICHE (A)
Wahrend des Betriebs schwankt die Brennerles-
tung zwischen:
• einer HÖCHSTLEISTUNG, die nicht höher
als die Höchstgrenze im Diagramm sein darf:
G350 MX = 390 KW
G500 MX = 510 KW
• und einer MINDESTLEISTUNG, die nicht nie-
driger sein darf als die Mindestgrenze des
Diagramms:
G350 MX = 55 KW
G500 MX = 130 KW
• und einer ZÜNDLEISTUNG, die innerhalb
des Bereichs A zu wählen ist.
Achtung
Der
REGELBEREICH
wurde
Raumtemperatur von 20°C, und einem barome-
trischen Druck von 1013 mbar (ungefähr 0 m
ü.d.M.) gemessen.
PRÜFKESSEL
Die
Regelbereiche
wurden
Prüfkesseln entsprechend Norm EN 676 ermit-
telt.
KOMBINATION VON KESSELN
Die Firma ICI Caldaie S.p.A. liefert den Brenner
G350 MX zur Kombination mit dem Kessel
MONOLITE 270 GT aus eigener Herstellung
sowie den Brenner G500 MX zur Kombination
mit dem Kessel MONOLITE 350 GT aus eigener
Herstellung. Bei der Einstellung der Brenner
muss die Höchstleistung des Kessels berück-
sichtigt werden, an dem sie installiert werden.
FIRING RATES (A)
During operation, burner output varies between:
• a MAXIMUM OUTPUT, which must not be
greater than the maximum limit given on the
diagram:
G350 MX = 390 KW
G500 MX = 510 KW
• and a MINIMUM OUTPUT, which must not be
lower than the minimum limit in the diagram:
G350 MX = 55 KW
G500 MX = 130 KW
• and a FIRING POWER, which must be cho-
sen within area A.
Important
The FIRING RATE area values have been
bei
einer
obtained considering an ambient temperature of
20°C, and an atmospheric pressure of 1013
mbar (approx. 0 m above sea level).
TEST BOILER
The firing rates were set in relation to special
an
speziellen
test boilers, according to EN 676 regulations.
BOILER COUPLING
ICI Caldaie S.p.A. supplies the G350 MX burner
for coupling with its boiler MONOLITE 270 GT,
and the G500 MX burner for coupling with its
boiler MONOLITE 350 GT. When calibrating the
burners, the maximum burner output of the
boiler on which they are installed must be taken
into consideration.
PLAGES DE PUISSANCE (A)
La puissance du brûleur en fonctionnement
varie entre:
• une PUISSANCE MAXIMUM, qui ne doit pas
• et une PUISSANCE MINIMUM, qui ne doit
• et une PUISSANCE D'ALLUMAGE qui doit
Attention
La PLAGE DE PUISSANCE a été calculée à
une température ambiante de 20°C, et à une
pression barométrique de 1013 mbar (environ 0
m au-dessus du niveau de la mer).
CHAUDIÈRE D'ESSAI
Les plages de puissance ont été établies sur
des chaiuières d'essai spéciales, selon la norme
EN 676.
ACCOUPLEMENT DE CHAUDIERES
ICI Caldaie S.p.A. fournit le brûleur G350 MX
pour l'assembler à sa chaudière MONOLITE
270 GT, ainsi que le brûleur G500 MX pour
l'assembler à sa chaudière MONOLITE 350 GT.
Au moment de régler les brûleurs, il faudra
prendre en compte la potentialité maximum de
la chaudière où ils seront installés.
11
être supérieure à la limite maximale du dia-
gramme:
G350 MX = 390 KW
G500 MX = 510 KW
pas être inférieure à la limite minimum du dia-
gramme:
G350 MX = 55 KW
G500 MX = 130 KW
être choisie dans la zone A.

Werbung

loading

Verwandte Produkte für ICI Caldaie G350 MX

Diese Anleitung auch für:

G500 mx851 t2852 t2