Silvercrest KH 1907 Bedienungsanleitung Seite 30

Programming the time
• Press the PROG 6 button.
CLOCK appears on the display 8.
• Repeatedly press the button HOUR 4 for hours,
resp. the button MIN 5 for minutes, until the correct
time is programmed in.
• Wait for approx. 15 seconds. The indicator
CLOCK disappears from the display 8.
The time display is now programmed.
or
• Press the button PROG 6 twice, so that only the
time is to be seen in the display 8. The time
display is now programmed.
Note:
If the coffee machine is separated from mains power
(or subject to a short power failure), the programmed
time is saved for a maximum of 15 seconds. In the
event of a longer separation from mains power, the
time must be reprogrammed.
Making coffee
Avoid brewing less than 4 cups of coffee. Otherwise,
the coffee will not have the desired temperature
and strength.
• Open the lid 1 and insert a filter bag (Size 1x4)
with folded over sides into the filter holder 2.
Using the measuring spoon w place coffee
powder into the filter bag. Subject to taste, you
will require approx one level measuring spoon w
of coffee powder per cup. A level measuring
spoon w approximates to about 6 gr of coffee
powder.
• Fill the water tank 3 with the required amount
of water. For this, use the scale 9.
Never fill the appliance with water beyond the
max-marking (12 cups).
• Close the lid 1, ensuring that it engages.
• Place the glass carafe q in the coffee machine.
• Press the button ON/AUTO/OFF 7 to start the
brewing process. The red indicator lamp integrated
into the ON/AUTO/OFF button 7 glows.
• When the brewing process is finished you can
remove the glass carafe q and serve the coffee.
If you do not wish to serve the coffee immediately,
allow it to stand in the coffee machine. The keep-
warm plate 0 will keep the coffee warm for 2
hours. After two hours the coffee machine switches
itself off automatically.
• If you wish to switch the coffee machine off
manually, press the button ON/AUTO/OFF 7
twice so that the integrated blue indicator lamp
glows constantly. After approx. 15 seconds this
extinguishes. The coffee machine is now
switched off.
Note:
Allow the coffee machine to cool down for approx. 5
minutes before commencing a further brewing process
or filling it with water.
Timer-Function
By use of the button PROG 6 you can programme
the coffee machine so that it starts the brewing process
at a pre-determined time. First, ALWAYS place cof-
fee powder in the filter bag in the filter holder 2
and water into the water tank 3.
Place the glass carafe q in the coffee machine.
Ensure that the water tank 3 is not filled beyond
the Max. marking (12 cups).
• Press the button PROG 6 twice, so that TIMER
appears in the display 8.
• Programme in the desired start time with the button
HOUR 4 and the button MIN 5 (see chapter
"Setting the Time").
- 28 -