Candy CRE H8A3DE-S Bedienungsanleitung Seite 67

WARNING
Don't touch the buttons while inserting
the plug because
calibrates the systems during the first
seconds: touching the buttons, the
machine couldn't work property. In
this case, remove the plug and repeat
the operation.
PROGRAMME SELECTOR with
OFF position
Rotating the programme selector in both

directions it's possible to select the
desired drying programme.
To cancel the selections or switch off the

appliance rotate the programme selector
on OFF (remember to unplug the appliance).
START/PAUSE button
Close the porthole BEFORE pressing
the START/PAUSE button.
To start the selected cycle with the preset

parameters, press START/PAUSE. When
the programme is running, the display will
show the time to elapse.
Moreover, if you want to modify the

chosen programme, press the desired
options buttons,
parameters and then press START/
PAUSE button to start the cycle.
Only the options compatible with the
set programme can be selected.
After switching on the appliance, wait a few

seconds for the programme to start running.
PROGRAMME DURATION
When a programme is selected the

display automatically shows the cycle
duration, which can vary, depending on
the options selected.
the machines
modify the default
Once the programme has started you will

be kept informed constantly of the time
remaining to the end of the drying cycle.
 The appliance calculates the time to the
end of the selected programme based
upon a standard loading, during the cycle,
the appliance corrects the time to the
humidity level of the load.
PROGRAMME END
"END" ("End" on some models) will

appear in the display at the end of the
programme, it is now possible to open the
door.
At the end of the cycle, turn off the

appliance by turning the programme
selector to the OFF position.
The programme
ALWAYS be put in the OFF position at
the end of the drying cycle before a
new one can be selected.
PAUSING THE MACHINE
Keep the START/PAUSE button pressed

for about 2 seconds (the residual time
display will flash, showing that the
machine is paused).
Press the START/PAUSE button again to

re-start the programme from the point it
had been paused at.
CANCELLING THE SET PROGRAMME
To cancel the programme, turn the

programme selector to the OFF position.
If there is a break in the power supply
whilst the machine is operating, when
the power is restored, by pressing the
START/PAUSE button, the machine will
restart from the beginning of the phase it
was in when the power was lost.
67
selector must