Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Note: The extractor hood's housing can be concealed within
the upper cabinet. In doing so, you must observe the following:
The intermediate floor must not be placed on the extractor
■
hood's housing.
The front panel must not be secured to the housing.
■
Access must be available in order to change the filter and for
■
after-sales service.
Appliance width, 90 cm:
You must also screw the appliance onto the side upper
cabinets.
Change the filter pull-out's limit stop
On some versions of the appliance, the limit stop for the filter
pull-out can be changed. Spacers are included with these
appliances in order to set the appliance's handle strip so that it
is flush with the fitted unit.
Pull the filter pull-out forwards.
1.
Shorten the spacer to the required dimension and insert it
2.
into the specified slot.
Connecting the pipes
Note: If using an aluminium pipe, smooth the connection area
beforehand.
Exhaust-air pipe Ø 150 mm (recommended size)
Attach the exhaust-air pipe directly to the air-pipe connector
and seal.
Exhaust-air pipe Ø 120 mm
Attach the reducing connector directly to the air-pipe
1.
connector.
Attach the exhaust air pipe to the reducing connector.
2.
Seal both joints appropriately.
3.
27
Werbung
