Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Prepare the appliance
A handle strip must be screwed into the filter pull-out. This can
be a supplied handle strip or one that is available as an
accessory
Use the enclosed screws to secure the handle strip to the
1.
filter-pull-out.
¨
Insert the enclosed power cord into the appliance.
2.
Screw the four angle brackets into the appliance. Observe
3.
the position of the screws.
screws to a distance of 8 mm.
26
©
When doing so, screw in the
ª
«
Installation
I n s t a l l a t i o n
Installation
Use the angle brackets to hang the appliance on the screws
1.
and align it.
Measure the distance from the appliance to the wall and
2.
mark this on the filler strip.
If required, shorten the filler strip to the required dimension.
3.
Remove the appliance and screw in the filler strip.
4.
Remount the appliance, align it and screw it in place.
5.
Carefully screw in all screws.
Establish the electrical connection.
6.
Werbung
