Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Replacing bulbs
These instructions apply to several appliance variants. It is
possible that individual features are described which do not
apply to your appliance.
:
Risk of burns!
Halogen bulbs become very hot when switched on. There is still
a risk of burning for some time after they have been switched
off. Allow the halogen bulbs to cool down before replacing
them.
:
Risk of electric shock!
When changing the bulbs, the bulb socket contacts are live.
Before changing the bulb, unplug the appliance from the mains
or switch off the circuit breaker in the fuse box.
Important Only use a bulb of the same type and same power
(see the bulb holder or rating plate inside the appliance) – to
do this, remove the metal mesh grease filter.
Replacing halogen bulbs
Note: When inserting halogen bulbs, do not touch the glass
tube. Use a clean cloth to insert the halogen bulbs.
Carefully remove the bulb ring using a suitable tool.
1.
Pull out the bulb and replace it with a bulb of the same type.
2.
Insert the bulb cover.
3.
Insert the mains plug or switch on the fuse again.
4.
LED lights
Defective LED lights may be replaced by the manufacturer, their
customer service or a qualified technician (electrician) only.
:
Risk of injury!
The light emitted by LED lights is very dazzling, and can
damage the eyes (risk group 1). Do not look directly into the
switched on LED lights for longer than 100 seconds.
After-sales service
Our after-sales service is there for you if your appliance needs
to be repaired. We will always find the right solution in order to
avoid unnecessary visits from a service technician.
When calling us, please give the product number (E no.) and
the production number (FD no.) so that we can provide you with
the correct advice. The rating plate with these numbers can be
found inside the appliance (remove the metal mesh grease
filter to gain access).
You can make a note of the numbers of your appliance and the
telephone number of the after-sales service in the space below
to save time should it be required.
E no.
O
After-sales service
Please be aware that a visit by an after-sales engineer will be
charged if a problem turns out to be the result of operator error,
even during the warranty period.
After-sales contact details for all countries can be found in the
attached after-sales service directory.
Accessories
(not included in the scope of delivery)
Note: These instructions apply to several appliance models. It
may be the case that an optional accessory that is listed does
not apply for your appliance.
Note: Observe the installation instructions in the accessory.
Accessories
Basic equipment:
Starter set for circulating-air mode
Throw-away filter for starter set
Handle strip: 60 cm:
Stainless steel
--------
FD no.
Order number
5Z5145X5
11008080
5Z5760N0
21
Werbung
