Werbung
| English |
PREPARATIONS
Note:
Do not connect the power cord to the wall outlet until all pre-
parations are completed
1, Unpacking and setting up (rigs. 1, 2, 3)
1. Unscrew 5 shipping screws (Q—@) off as shown in Fig. 1
&2.
2. Take off shipping corners (@ — @) and others (@-@)
3. Slide the main weight () onto the weight axis as close
to the tonearm base as possible. (Fig. 3)
4. Mount the platter on the center spindle of the motor with
care not to damage the motor shaft and place the platter
mat on top of the platter.
2. Mounting the cartridge (Figs. 4, 5)
Removal and mounting of the headshell (Fig. 4)
Turn the connector
nut in the direction of "A" to remove
Fig. 3 Abb. 3
the headshell from the tonearm. Turn it in the direction of
"B" for mounting the headshell
Mounting cartridge (Fig. 5)
1. Remove the 2 screws securing the cartridge on the head-
shell
2. Install your cartridge onto the headshell provided or onto
Cartridge securing screws
Tonabnehmer Betestigungsschrauben
Vis de blocage de la cellule
Green (RE)
a headhsell of your selection.
Sor (ee)
baediac
3. The four headshell lead wires are colour-coded as follows,
Tenabnehmes
connect them correctly:
getter
ee
White (4)... 00.0.8. Lo Red (+).
oak
Rouge (R)
Blue(-)..........LE
Green (-).
. RE
(Left)
(Right)
—~Blue (LE)
Brau (LE)
si
f
heedshell and I
Biau (UE
yr!
4, Mount the caruidge properly onto the heedshell and
leave
White (L)
the set screws slightly loosened, then, after completing the
'Wei (L)
"overhang adjustment" (see below) tighten them firmly.
Blane)
5. After each cartridge replacement, be sure to perform
ocean
"ANTI-SKATING
TRACKING
FORCE"
adjustment,
Coquille
which
automatically
set to the optimum
value when
selecting a stylus force.
Note: The cartridge and stylus is not supplied with turn-
tables for U.S.A., Canada and the U.K.
Fig. 5 Abb. 5
3. Overhang adjustment (Fig. 6)
Stylus
Cartridge securing screws
5
Abtastnade!
'Tonabnehmer-Befestigungsschrauben
Adjust the overhang as shown. The headshell of this model
Polnte de lecture
B / Visde blocage de la cellule
has 1mm graduations on the top side in the "'b" part to
make the adjustment easier. If "a" distance is OO mm, slide
the finger lift to a position of "48 — OU = UU", and fix the
screws. Tolerance of +1 mm will not harm performance.
If a JVC cartridge is used, the designated distance "a" is 8
Headshell
mm, slide the finger lift of the headshell to a position of 40
See irate
mm, according ta distance "'b", "48 — 8 = 40".
Fig.
6 Abb. 6
~3-
Werbung
