STIEBEL ELTRON DEL 27 SL electronic LCD Bedienung Und Installation Seite 33

INSTALLATION
Installation
Water installation on finished walls, fitting the appliance cover
4
3
2
1
1 Back panel guides
2 Screw
3 Cover guides
4 Pipe aperture
f Cleanly break out the knock-out apertures in the appliance f
cover. If necessary, use a file.
Note
If the tap connection pipes are slightly offset, the appli-
ance can be sealed using the tabs on the cover guides.
f If the tap connection pipes are offset, do not fit any f
back panel guides.
f If installing tap connection pipes which are not offset, break f
off the tabs on the cover guides.
f Click the cover guides into place in the pipe apertures. f
f Position the back panel guides on the pipes. Push them to- f
gether. Then push the guides until they are resting against
the back panel.
f Secure the back panel at the bottom with a screw. f
Installation of lower back panel with threaded fitting on
finished walls
You can install the lower back panel after fitting the taps.
2
1 Connection pieces delivered in the pack
2 Screw
f Cut open the lower back panel at the markings. f
f Fit the lower back panel by bending it out at the sides and f
guiding it over the pipes.
f Insert the connection pieces into the lower back panel from f
behind.
f Click the lower back panel into place. f
f Secure the lower back panel with a screw. f
www.stiebel-eltron.com
1
Wall mounting bracket when replacing an appliance
When replacing an appliance, you can use an existing wall mount-
ing bracket of a Stiebel Eltron appliance (except for a DHF instan-
taneous water heater).
f Press the appliance over the threaded stud of the existing f
wall mounting bracket. When doing so, push through the soft
seal in the back panel of the appliance. If necessary, use a
screwdriver.
DHF replacement
f Reposition the threaded stud on the wall mounting bracket f
(the stud has a self-tapping thread).
f Rotate the wall mounting bracket 180° and mount it on the f
wall (the DHF logo is then turned towards the reader).
Installation with offset tiles
20
2
1
1 Minimum contact area of the appliance
2 Maximum tile offset
f Adjust the wall clearance. Lock the back panel with the fixing f
toggle by turning it 90° clockwise.
DEL SL electronic LCD | 33