STIEBEL ELTRON DEL 27 SL electronic LCD Bedienung Und Installation Seite 30

INSTALLATION
Installation
1 2
1 Plastic profile washer
2 Flow limiter
Note
f Install the blue flow limiter (7.5 l/min) as standard. f
f Use the brown flow limiter (12 l/min) in the follow- f
ing instances:
- With an increased cold water inlet temperature, e.g.
in the case of water preheated by solar energy.
- When using the appliance for showering.
f With low water pressure.The pressure drop can be f
reduced by replacing the flow limiter with the plastic
profile washer provided.
Installing the appliance
f For easy installation, push the cable grommet of the upper f
electrical connection into the back panel from behind.
f Remove the transport plugs from the water connections. f
f Remove the fixing toggle from the upper part of the back f
panel.
f Route the power cable through the cable grommet from be- f
hind, until the power cable rests against the cable sheath.
Align the power cable.
If the cross-section is > 6 mm², enlarge the hole in the cable
grommet.
f Press the appliance over the threaded stud of the wall f
mounting bracket. When doing so, push through the soft
seal in the back panel of the appliance. If necessary, use a
screwdriver.
30 | DEL SL electronic LCD
f Push the fixing toggle on to the threaded stud of the wall f
mounting bracket.
f Push the back panel of the appliance on to the wall. Turn the f
fixing toggle 90° clockwise to lock the appliance in place.
19
3 Nm
f Fit the pipes with flat gaskets onto the twin connectors. f
Connecting the power supply
WARNING Electrocution
Carry out all electrical connection and installation work
in accordance with relevant regulations.
WARNING Electrocution
Connection to the power supply is only permissible in the
form of a permanent connection in conjunction with the
removable cable grommet. Ensure the appliance can be
separated from the power supply by an isolator that dis-
connects all poles with at least 3 mm contact separation.
WARNING Electrocution
Ensure that the appliance is earthed.
Damage to the appliance and environment
!
Observe the type plate. The specified voltage must match
the mains voltage.
f Connect the power cable to the mains terminal (see chapter f
"Specification / Wiring diagram"). The specified voltage must
match the mains voltage.
24
5 Nm
www.stiebel-eltron.com