Herunterladen Inhalt Inhalt Diese Seite drucken

Completing The Installation; Installation Options - STIEBEL ELTRON DEL 27 SL electronic LCD Bedienung Und Installation

Elektronisch geregelter durchlauferhitzer
Vorschau ausblenden Andere Handbücher für DEL 27 SL electronic LCD:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

INSTALLATION
Installation
Adjustable connected load
With the
, 3 connected load stages can be select-
DEL 18/21/24 SL
ed. The middle load is preset. With a different connected load,
proceed as follows:
f Select the connected load you require (see chapter "Specifi-
f
cation / Data table").
f Plug in the coding card according to the selected connected
f
load.
f Change the type plate. Tick the selected connected load.
f
Please use a ballpoint pen to do this.

10.2 Completing the installation

f Open the 3-way ball shut-off valve.
f
f Fit the lower part of the back panel. Ensure that it clicks into
f
place.
f Align the mounted appliance by loosening the fixing toggle,
f
aligning the electrical connection and back panel, and then
re-tightening the fixing toggle. If the back panel of the appli-
ance is not flush, the appliance can be secured at the bottom
with an additional screw.
www.stiebel-eltron.com

10.3 Installation options

- Electrical connection from above on unfinished walls
- Electrical connection on finished walls
- Large cross-section for electrical connection from below
- Connecting a load shedding relay
- Water installation on finished walls
- Water installation for finished walls with solder / compres-
sion fitting
- Water installation on finished walls, fitting the appliance
cover
- Installation of lower back panel with threaded fitting on fin-
ished walls
- Use of existing wall mounting bracket when replacing an
appliance
- Installation with offset tiles
- Pivoting appliance cover
- Operation with preheated water
- Anti-scalding protection / temperature limit
Electrical connection from above on unfinished walls
f Cut open the cable grommet for the power cable.
f
f Push down the locking hook to secure the mains terminal.
f
Pull out the mains terminal.
f Reposition the mains terminal in the appliance from the
f
bottom to the top and secure the mains terminal by sliding it
under the locking hook.
f Route the control wires below the wire guide.
f
DEL SL electronic LCD |
31

Quicklinks ausblenden:

Werbung

Kapitel

Inhaltsverzeichnis
loading

Inhaltsverzeichnis