Werbung
r
w
q
e
y
t
SECTION II. GETTING READY TO SEW
Connecting Machine to Power Supply
IMPORTANT: When using your sewing machine the first
few times, place waste fabric under the presser foot and
run the machine without thread for a few minutes. Wipe
away excess oil.
Before connecting the power cord, make sure the
voltage and frequency shown on the machine are
identical to your electrical power.
To connect machine to power supply, turn off the power
switch q. Insert the foot control plug w and machine
plug e into the machine sockets r. Insert the power
supply plug t into the wall socket y.
When the power is turned on, the indicator window will
show a test pattern then will indicate 01.
For Your Safety
Do not use extension cords or plug adapters.
Do not touch plug with wet hands.
Always turn off the power/light switch first and then
unplug from the electrical outlet. Examples:
• when leaving the machine unattended
• when cleaning the machine
Always turn off the power/light switch:
• when attaching or removing parts such as
needle, presser foot, needle plate
• when threading needle or bobbin
Do not place anything on the foot control.
Do not place heavy items on cords. Do not subject cords
to heat. Do not use damaged cords. Have the cord
repaired immediately.
While the machine is in operation, always keep your eye
on the sewing area and do not touch any moving parts
such as the thread take-up lever, flywheel or needle.
Your machine may come equipped with a
polarized plug (one prong wider than the other). A
polarized plug reduces the risk of electrical shock.
This plug is intended to fit into a polarized outlet. If the
plug does not fit fully into the outlet, reverse the plug. If
it still does not fit, contact a qualified electrician to install
the proper outlet. Do not modify the plug in any way.
6
Werbung
