Compact Disc - Onkyo R-100 Bedienungsanleitung

Connecting Speaker Cables
CAUTION:
When using banana plugs, make sure the speaker terminal screws
are screwed in firmly before inserting banana plugs.
: Remote Interactive)
transmitter. ( FRI
R-100
COMPACT DISC eee
PLAYER C-100 | °°
FRI remote
control cable
Remote control operation is not possible when only the remote
Gontrol cable is connected. Remote control cable and connecting |
cable must be connected.
Turntable Connections (PHONO)
Connect the output leads of the turntable to the PHONO jacks.
Be sure to connect the ground (earth) lead wire from the turntable
to the ground terminal (GND): "Lack of proper ground connection
will cause hum. Turntables not provided with GND wires do. not
need to be connected.
1. Place the turntable on a firm shelf or deck free from vibrations
(especially those generated by the speaker system). If the
turntable is permitted to pick up such unwanted vibrations, not
only will the performance of the unit drop, but-distortion in the
bass frequencies and howling in the speakers may also. occur.
Check the turntable instruction manual for any other precautions.
The loud noises that occur when connecting and disconnecting
the turntable leads, replacing the cartridge or lowering the
tonearm could damage the speakers. Always turn the power
switch off before making connections.
wn
Compact Disc Player (CD)
Tape Deck Connections (TAPE)
Video Disc Player (or Video Cassette Player) Connections
(VDP)
player to the R-100 VDP "VIDEO" jack and the AUDIO output to
the VDP "AUDIO" jacks. The VDP jacks are only for playback, there
is no REC jack. For more details, refer to the video disc player in-
struction manual.
Video Cassette Recorder Connections (VCR)
41. Connect the VIDEO output of the VCR to the rear panel (VIDEO)
VCR "IN" jack and the VIDEO input of the VCR to the rear panel
(VIDEO) VCR "OUT" jack. Then connect the AUDIO output
of the VCR to the (AUDIO) VCR L and R "IN" jacks. Finally,
connect the AUDIO input of the VCR to the (AUDIO) VCR L
and R "OUT" jacks.
2. When using a playback-only VCR, only the output connections
need to be performed.
Monitor TV Connection
A monitor TV set can be connected to the VIDEO MONITOR OUT
jack.
Processor Jacks
Be sure to connect the jumper plugs when the processor is not in
use. (No sound will come from the speakers.)