Werbung
Verfügbare Sprachen
Verfügbare Sprachen
▶ swing the tool arm to the left/right to 45°
▶ check for a 135° angle between blade and table with
a mitre square
▶ check that bevel indicator P is on the 45° mark
▶ if necessary, adjust the 45° blade alignment as fol-
lows:
1) swing the tool arm back to 0° and adjust screw up or
down
2) swing the tool arm back to 45°, re-check, and repeat
if necessary
Checking/adjusting of 90° fence alignment
▶ disconnect the plug
▶ rotate the saw table to the 0° position
▶ lower the tool arm and lock in place
▶ check for a 90° angle between blade and fence with a
square (ensure the square contacts the saw blade body
and not its teeth)
▶ if necessary, adjust the 90° fence alignment as fol-
lows:
1) loosen 2 hex screws
2) adjust fence until blade and fence have full contact
with the square
3) tighten 2 hex screws
Adjusting of mitre angle indicator
▶ disconnect the plug
▶ set tool into working position
▶ loosen Phillips screw that holds indicator in place
▶ position indicator to align with the 0° mitre mark
▶ tighten Phillips screw
Adjusting of bevel angle indicator
▶ disconnect the plug
▶ loosen screw and align indicator to the 0° mark
▶ tighten screw
APPLICATION ADVICE
Special workpieces
▶ ensure that curved or round workpieces are especially
secured against slipping
▶ at the cutting line no gap may exist between the work-
piece and the fence or saw table
▶ if necessary, fabricate a special fixture ensure mini-
mum splintering
Only use sharp saw blades of the correct type
▶ quality of cut improves by the number of teeth
▶ carbide tipped blades stay sharp up to 30 times longer
than ordinary blades
MAINTENANCE / SERVICE
▶ This tool is not intended for professional use
▶ Always keep tool and cord clean (especially the venti-
lation slots at the back-end of the motor housing)
▶ disconnect the plug before cleaning
▶ Clean saw blade immediately after use (especially
from resin and glue)
▶ the saw blade becomes very hot during use; do not
touch it before it has cooled down.
After-sales Service and Customer Assistance
Our after-sales service responds to your questions con-
cerning maintenance and repair of your product as well
as spare parts.
Our customer service representatives can answer your
questions concerning possible applications and adjust-
ment of products and accessories
Disposal The machine, accessories and packaging should be
sorted for environmental-friendly recycling.
Do not dispose of power tools into household waste!
Only for EC countries:
According the European Guideline 2002/96/EC for Waste
Electrical and Electronic Equipment and its implementa
tion into national right, power tools that are no longer
usable must be collected separately and disposed of in an
environmentally correct manner.
Subject to change without notice.
KRAISSMANN Power Tools Ltd.
North Rhine-Westphalia, Dusseldorf,
Germany
Mit r e s aw | 15
Werbung
