Scheppach DH8000x Originalbetriebsanleitung Seite 25

10. Maintenance
The air dehumidifier is designed for a trouble free op-
eration and a minimum of maintenance. All movable
parts are permanently lubricated. Inside the device,
there are no other parts to be maintained.
Cleaning
• Keep all safety devices, air vents and the motor
housing free of dirt and dust. Wipe the equipment
with a clean cloth or clean it with compressed air at
low pressure.
• We recommend that you clean your device after
each use.
• Clean the unit regularly with a damp cloth and some
soft soap. Do not use cleaning agents or solvents;
they may damage the plastic parts of the appliance.
Make sure that no water can get inside the unit.
Service information
Please note that the following parts of this product are
subject to normal or natural wear and that the follow-
ing parts are therefore also required for use as con-
sumables.
Wear parts*: Wheels
* Not necessarily included in the scope of delivery!
Spare parts and accessories can be obtained from
our service centre. To do this, scan the QR code on
the cover page.
11. Electrical connection
The customer's mains connection as well as
the extension cable used must also comply with
these regulations.
Damaged electrical connection cable
The insulation on electrical connection cables is of-
ten damaged.
This may have the following causes:
Pressure points, where connection cables are
•
passed through windows or doors.
Kinks where the connection cable has been im-
•
properly fastened or routed.
Places where the connection cables have been cut
•
due to being driven over.
Insulation damage due to being ripped out of the
•
wall outlet.
Cracks due to the insulation ageing.
•
Such damaged electrical connection cables must not
be used and are life-threatening due to the insula-
tion damage.
Check the electrical connection cables for damage
regularly. Ensure that the connection cables are dis-
connected from electrical power when checking for
damage.
Electrical connection cables must comply with the
applicable VDE and DIN provisions. Only use con-
nection cables with the designation H05RR-F.
The printing of the type designation on the connec-
tion cable is mandatory.
The mains voltage must be 230 V~
•
Extension cables up to 25 m long must have a
•
cross-section of 2.5 mm
Connections and repair work on the electrical equip-
ment may only be carried out by electricians.
Please provide the following information in the event
of any enquiries:
Data of machine type plate
•
12. Transport
Always transport the air dehumidifier in upright (verti-
cal) position to prevent compressor damages.
If you have transported the air dehumidifier in another
than upright position (horizontal or tilted), allow the air
dehumidifier to stand in upright position for at least
one hour before starting it up.
13. Storage
Store the device and its accessories in a dark, dry
and frost-free place that is inaccessible to children.
The optimum storage temperature lies between 5 and
30 ˚C. Store the tool in its original packaging. Cover
the tool to protect it from dust or moisture. Cover the
tool to protect it from dust or moisture. Store the oper-
ating manual with the tool.
14. Disposal and recycling
Notes for packaging
Notes on the electrical and electronic equipment
act [ElektroG]
Waste electrical and electronic equip-
ment does not belong in household
waste, but must be collected and dis-
posed of separately!
www.scheppach.com
.
2
The packaging materials are
recyclable. Please dispose of
packaging in an environmen-
tally friendly manner.
GB | 25