Zodiac FREERIDER RF 5200 iQ Kurz- Oder Schnellstartanleitung Seite 7

Immerse
the cleaner
1
Attach the cord of the floating ring to one
of the cleaner's handles. The length must be
adjusted to the maximum depth of the pool.
2
Immerse the cleaner and hold it underwater
to help remove any air.
3
Let the cleaner sink to the bottom of the pool.
The cycle will begin 30 seconds after the
cleaner detects that it is in water.
• A cycle normally lasts 1h30.
• Do not immerse the cleaner if the protective
cap hasn't been replaced in the charging
port.
• Do not immerse the robot in a saltwater swim-
ming pool, chlorine compatibility only.
• Make sure the floating ring stays on the sur-
face of the water.
• Only use the floating ring in flat bottom pools.
3
• At the end of the cleaning cycle: the cleaner stops at the foot of a wall.
• Use the floating ring and/or the hook to remove the cleaner from the water.
or
• The cleaner can be removed mid-cycle - the cleaner will stop automatically as soon as it is out of the water.
Remove
the cleaner from the water
Catch the floating ring and
pull the cleaner toward you.
Fasten the hook (included) to
the end of a pool pole (not
included).
4
Completely remove the
cleaner from the water by
the handle.
Hook onto the cleaner's front
handle and lift the cleaner to
the surface.
7
EN