Zodiac FREERIDER RF 5200 iQ Kurz- Oder Schnellstartanleitung Seite 6

This guide (which is a translation of the original French version) contains the basic instructions for installation and start-up. Read the full online user manual and safety
instructions before beginning installation.
Discover
the package contents
+
Hook* Floating ring
& cord
* A pool pole (standard model, not included) is required to remove the
cleaner from the water.
Charge
Rear
handle
Filter acces
Front
handle
3
Design
Brush
Indicator
light (LED)
On/Off slider
Charging port
CONFIDENTIAL - BLANC TAILLEUR DESIGN R&D
& protective cap
Tracks 1
Lift open the protective cap at the back of the
cleaner. Make sure the charging port is totally
dry and connect the charger to the charging
port.
2
Connect the charger to the mains :
- indoors,
- without direct sun exposition,
- 3.5 m from the pool.
3
Check that the cleaner is charging correctly: the
LED flashes orange or green.
• See ''Indicator light'' section for more details about
the LED.
Charger
• Only use the charger supplied.
• Charging stops automatically when the
temperature is below 5°C and above 43°C.
1
the cleaner
1
Start
a cycle
When the LED is off or flashing green, the clea-
1
ner is charged enough to launch a complete
cycle:
- Unplug the cleaner - the LED turns off,
- Replace the protective cap in the charging
port,
- Carry the cleaner to the pool.
Push down the slider to start a cycle. The LED
2
turns to solid green : the cleaner is ready to be
immersed.
Attention: You have 30 seconds after starting a
cycle to put the cleaner in the water, otherwise
you must restart the cycle.
• See ''Indicator light'' section for more details about
the LED.
2
EN
6