Assembly Procedure - Rehau RAUTOOl K10 Bedienungsanleitung

RAUTOOl K10/K12/K14

AsseMblY pROcedURe

1. Using pipe cutters 25, cut pipe to
required length at right angles without
leaving burrs.
Attention!
Keep your hand at a safe dis-
tance from the tool. Do not use
saws or similar devices!
5. Press lever together and maintain in
position for approx. 5 sec.
9. Press lever together rapidly, avoiding
jerky movements and compress compres-
sion sleeve up to the fitting collar.
8
2. Bring tool into starting position. Open
movable lever completely (≥50°).
6. Bring tool into starting position and
remove expanded pipe. (Open movable
lever completely).
3. Slide compression sleeve into tool.
Attention!
Inside taper of the compression
sleeve must point forwards.
7. Insert fitting into pipe up to the stop.
After a brief period the fitting will sit
tightly in the pipe (memory effect).
Attention!
Before the full memory effect
takes place, the fitting may fall
out of the pipe! Make sure the
fitting is in a straight position.
4. Slide pipe through the compression
sleeve into the tool up to the stop.
8. Attach tool completely to the joint.
Caution!
Do not tilt! Tool must be applied
over full surface and at right
angles.