Navigation - Autocom Charger Bedienungsanleitung

Auto-Detect :
Enable (ON) or disable (OFF) the AUTO-DETECT function. This function automatically starts a charge when a battery is connected
to the charger.
Date :
Setting the date and time.
Cable calibration :
Procedure for calibrating the charging cables of the device, so that the charger optimally compensates for the voltage drop due
to the cables. It is strongly recommended to perform this procedure at least once a year and each time the charging cables are
replaced.
Calibration procedure :
1 Press SELECT to enter the CABLE CALIBRATION submenu
2 Short-circuit the clamps
3 Press START/STOP to start the calibration
: The calibration was successful.
4
Err19: Cable_NOK : A problem occurred during cable calibration.
Check that the cables are in good condition and correctly short-circuited and repeat the operation.
USB connectivity :
Sub-menu to access USB features.
Multi-Chargers Mode:
A function that allows multiple chargers to be parallelized to increase power.
 Refer to the SHM - Smart Hub Module (025981) manual for more details.
To operate normally with a single charger, this feature must be set to OFF.
USB CONNECTIVITY
Your Autocom CHARGER is equipped with USB connectivity that extends its functionality by creating custom configurations on your
computer that can then be downloaded to the device via a simple USB stick. The custom configuration allows you to add, delete or
modify charging modes and profiles, so that your charger can be adapted to your needs.
USB connectivity also gives you the ability to retrieve the history and data of more than 100 recharge on a USB stick and run them
on a spreadsheet.

Navigation :

1 Use the arrows to scroll through the different submenus or files available
2 Press the SELECT button to enter the submenu or select a file.
3 Use the MODE button to return to the previous submenu
10 10
Ensure that the metal parts of the jaws to which the cables are attached are in good
contact with each other.
OK
Autocom CHARGER
NOK
EN
NOK